MINN KOTA i-Pilot Micro Remote Bluetooth User Guide
- June 5, 2024
- MINN KOTA
Table of Contents
MINN -KOTA i-Pilot -Micro- Remote -Bluetooth
REMOTE
NOTICE: If your motor is connected to a Heading Sensor, the Speed Down (backwards), Speed Up (forward), Steer Right and Steer Left buttons function change to Jog the boat while in Spot-Lock.
Pairing the Micro Remote to your Controller
An i-Pilot controller may pair up to 5 remotes. These five remotes can be a combination of standard i-Pilot remotes and Micro Remotes. Any additional remotes can be paired using the following steps. Once the maximum number of remotes have been paired, the controller will start replacing the oldest paired remote in memory with the new remote.
-
Power up the trolling motor.
-
Locate the Pair PAIR button at the top of the Control Head.
-
Push and hold the Pair PAIR button down. A consistent tone will be emitted from the Control Head.
NOTICE: Make sure the remote stays within range of the Control Head during the pairing process. -
4. While holding the Pair PAIR button on the Control Head, push and hold the High Speed Bypass button and AutoPilot button on the remote simultaneously.
MANUAL CONTROL BUTTONS
- Speed Down & Speed Up
- Press to decrease or increase motor speed.
- Prop On/Off
- Pressing this button will turn the Prop on and off.
- Steer Left & Steer Right
- Press to steer the motor to the left or to the right.
- High Speed Bypass
- Bypasses the current motor speed to speed 10. Double press to engage. Single press to disengage
NAVIGATION BUTTONS
- Spot-Lock
- Press to enable Spot-Lock. When Spot-Lock is enabled from the Micro Remote, use either the i-Pilot or i-Pilot Link remote, or the fish finder if you want to save it.
- AutoPilot
- Press to enable AutoPilot. The selection between Legacy AutoPilot and Advanced AutoPilot must be made from either the i-Pilot or i-Pilot Link remote.
NOTICE: When the remote is being paired to the i-Pilot Controller, the High Speed Bypass button and the AutoPilot button need to be held down simultaneously. Make sure to also hold the Pair PAIR button on the Control Head to successfully pair the remote to the controller.
5. Once successfully paired, 3 longer beeps will be emitted from the Control Head and the remote will be paired.
NOTICE: A remote can be paired to one controller at a time. A controller
can have multiple remotes paired to it.
Scan to view the complete Micro Remote Owner’s Manual online. The Owner’s Manual is available at minnkotamotors.com and includes informaton on compatibility, safety considerations, compliance, maintenance, parts and more.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>