Qianren M1 Accio Touch User Manual
- May 15, 2024
- Qianren
Table of Contents
Qianren M1 Accio Touch
Product Function
- Strip, Suck, Leisure
- Product Standard
- Product Name: Accio Touch
- Product Material: ABS+TPE
- Product Size: 2819083mm
- Machine Weight: 850g
- For the Crowd: People aged 18 and above
- Accessories: Manual, USB data cable
Product Diagram
- Power Supply Mode: 3. 7V battery
- Rated Current: ≤ 500mA
- Power Supply Mode: USB charging
- Endurance Time: About 1 hour
- Maximum noise: < 65 decibel
Instructions
- Hold: for power on and off.
- Hold VR: tailor-made for simulation experiences that sync with any oral content; compatible with VR, smartphone and PC.
- Hold : programmed motion control enabling a convenient journey with exciting surprises.
- Click : to pause and continue.
- After using the product, press the power button to turn off the power, clean it thoroughly, and store it dry.
- Please fully charge before use.
Button Description
Maintenance
- Before use please wash the internal soft plastic with clean water or cleaning solution, and then wipe it dry.
- It is prohibited to store the product in a place close to a fire source or in a high-temperature, humid place for a long time.
Caution
- This product is an adult toy and is prohibited for minors to use.
- For hygiene reasons, it is recommended to use it together with condoms.
- To protect your skin, it is recommended to use it together with lubricants.
- Please store the product in a cool and dry place away from children.
- If discomfort occurs during use, please stop using immediately.
- Do not use alcohol, gasoline, or acetone cleaning agents to clean the product.
Bluetooth connection
- Long press the power button to turn on the device.
- Long press the VR button to enter Bluetooth pairing mode and the VR light will flash.
- Open the page in the video playback device, and click connect. and after a successful Bluetooth connection, the VR light will remain on.
Accio
Suitable for all platform content
Enterprise-level Al algorithms
High synchronization, high sensitivity
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, under part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used per the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF waming for Portable device
The device has been evaluated to meet the general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>