stack on SS-16-MB-B Steel-Security-16-Gun-Safe-Biometric-Lock Instructions
- June 5, 2024
- STACK-ON
Table of Contents
stack on SS-16-MB-B Steel-Security-16-Gun-Safe-Biometric-Lock
IMPORTANT
- Record the serial number from the tag on the back of the safe or from the tag on the front bottom corner of the safe.
- Keep keys in a secure place away from children.
- Do not store the backup key, or this document in the safe.
- Do not move this safe using its handle. The handle should only be used for opening and closing the door of the safe.
- Warning: Keep your safe closed and locked at all times when not in use. Children could accidentally be locked inside the safe.
BATTERY INSTALLATION
You must first install the batteries which are located in the front protective Styrofoam. This safe uses 4 – AAA batteries. Under normal use, batteries will last about 1 year.
- NOTE: Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries.
- NOTE: When changing or installing the batteries, do not pull on the wires. Doing this could cause the power supply to become disconnected from the lock.
- NOTE: If the batteries are low, the yellow light will flash when you press the scanner.
To replace the batteries, remove the lock faceplate by pressing the tab and turning the cover as shown in the illustration below. Open the battery compartment located on the back of the lock faceplate. See the illustration below. After batteries are installed, reattach the faceplate by twisting it on in the opposite direction of the illustration on previous page.
BACK VIEW
NOTE: The red reset button located on the inside of the door, is covered with a removable red cap. When you use the red reset button while setting your own combination, remove the cap to access the button. Replace the cap securely over the reset button after setting your combination. Failure to do so will compromise the safety and security of the safe.
RECORDING FINGERPRINTS
When you first receive your safe there are no recorded fingerprints. For security you must record a fingerprint. Failure to do so will compromise the safety and security of the safe. You can record up to 20 different fingerprints for opening the safe. For best results, each individual should use their thumb or index finger only. To record a fingerprint, first press the Reset Button on the inside of the safe. The scanner will turn blue with two beeps (if the sound is turned on) and the green light flashes twice, you will then record the same finger three times as follows:
- Place your finger on the scanner until there is one beep (if the sound is turned on) and the green light flashes once. Lift your finger off the scanner.
- Place the same finger on the scanner for a second time, holding the finger in the same position until there is one beep (if the sound is turned on) and the green light flashes once. Lift your finger off the scanner.
- Place the same finger on the scanner for a third time, holding the finger in the same position until there is two beeps (if the sound is turned on) and the green light flashes twice. Lift your finger off the scanner. Your fingerprint is now recorded.
If the red light flashes three times with three beeps (if the sound is turned
on) your fingerprint did not get recorded and you will have to start over. If
you enter more than 20 fingerprints, the red light will flash 5 times and
there will be 5 beeps (if the sound is turned on).
NOTE: In certain dry climate conditions, your fingerprint may not scan.
If your fingerprint did not scan, we recommend moisturizing with minimal
lotion and trying again.
OPENING THE SAFE USING YOUR FINGERPRINT
To open the safe, press the scanner with a recorded finger. The blue light will come on with one beep (if the sound is turned on) and the scan will begin. If the green light flashes twice with 2 beeps (if the sound is turned on), the scan has been accepted and you will have 5 seconds to turn the handle to open the door. If the red light flashes once, the scanner did not read your fingerprint and you must try again. If the red light flashes 3 times, the scanner read your fingerprint and did not accept it. If there are 3 rejected scans, where your the fingerprint was read, and the red light flashes 5 times with 5 beeps (if the sound is turned on), you will have an automatic lockout for 60 seconds before you can try a scan again. The safe will beep one time (if the sound is turned on) and the green light will flash once when the lockout period is over. If there is 1 more rejected scan where your the fingerprint was read and the red light flashes 5 times with 5 beeps (if the sound is turned on), you will have an automatic lockout for 5 minutes before you can try a scan again. The safe will beep one time (if the sound is turned on) and the green light will flash once when the lockout period is over.
TURNING THE SOUND OFF/ON
- Your safe comes with the beep sound turned on.
- To turn the sound off, press the scanner with a recorded fingerprint for 10 seconds until the green light flashes twice.
- To turn the sound on, press the scanner with a recorded fingerprint until you hear two beeps and the green light flashes twice.
CLEARING THE MEMORY
To clear the memory of all recorded fingerprints, locate the reset button on
the inside of the safe and press this button for about 5 seconds until the
green light flashes 10 times with 10 beeps (if the sound is turned on). All
recorded scans will be erased.
NOTE: For security, you must record a fingerprint. Failure to do so will
compromise the safety and security of the safe.
LOCKING THE SAFE
To lock the safe, close the door and rotate the handle counterclockwise until
it stops. If the handle is not turned until it stops, the locking mechanism
will not lock.
NOTE ON LOCKING THE SAFE: Because the locking mechanism is deactivated
for approximately 3 to 6 seconds after the fingerprint is entered, wait a
minimum of 6 seconds from the time the combination is entered to lock the
safe.
SELECTING A LOCATION
The safe must be mounted to the floor. For optimal safety and security, the safe should be installed adjacent to a side wall with minimal space on either side of the safe, in an isolated, dry and secure area. e safe should be flat against the wall and floor. Remove the baseboard if necessary.
SECURING THE SAFE
NOTE: The safe must be secured to the floor. Use the hardware provided or
consult your hardware retailer for fastening hardware for your particular
mounting surface.
NOTE: This safe must be mounted to the floor. Failure to do so will
compromise the safety and security of the safe. Mark the holes to be used.
Drill the appropriate diameter and depth of pilot holes depending on the type
of hardware being used and the type of mounting surface. Secure the safe with
the fasteners.
BACK UP KEY
A “Back Up Key” has been provided in case the batteries run low. If you lose your key, you may purchase a replacement key be referencing the serial number located on the back of your safe or the front lower right corner. See section regarding replacement keys for further information.
- Remove the cover by pressing the tab and turning the cover as shown in the illustration. The lock can hang by the connecting cable while unlocking the safe.
- Insert the key in the key hole and turn clockwise 1/4 turn (until stopped) in order to unlock the safe. Rotate the handle and open the door.
- Keep the door open until you have entered a new security code. Before entering your new code, remove the key and screw the cover back in place.
INSTALLATION OF SCOPE STAND-OFF
NOTE: The scope stand-off will function properly for many combinations of guns with scopes.Screw the scope stand-off into the pilot hole of the barrel rest.
MAINTENANCE
Do not use glass cleaners or sprays on this safe. Clean with a damp cloth.
DOOR ORGANIZER
A door organizer is included with this safe. The top tray of the door
organizer can be adjusted by removing the two screws and relocating the tray
.
References
- On.com
- STACK-ON – Stack-On Products – Safes, Gun Safes, Gun Security…
- STACK-ON – Stack-On Products – Safes, Gun Safes, Gun Security…
- STACK-ON – Stack-On Products – Safes, Gun Safes, Gun Security…
- Customer Service – STACK-ON
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>