TOPEAK TW018 SWING-UP EX Bike Holder User Guide
- June 5, 2024
- TOPEAK
Table of Contents
TOPEAK TW018 SWING-UP EX Bike Holder
PARTS LIST
- Main Unit
- Rear Wheel Holder Unit
- Screws and Wall Anchors
- ø5 x 30L screw x 4 pcs
- ø7 x 35L wall anchor x 4 pcs
- Tool Required: Phillips screw driver & 3 mm / 5 mm Allen keys
NOTE The bottom wheel must have a ground clearance of 2.54 cm (1”) when a bike is in the Swing-Up Bike Holder.
LIMITATION
Swing-Up EX Bike Holder is compatible with wheel / tire combinations having an overall height of 8cm (3.15”) and tire width up to 2.6”
INSTALLATION
MONTAGE
INSTALLING MAIN UNIT
- OPTION A : Into solid wall (Non wood)
- Mark locations for drilling.
- OPTION B : Into solid wooden wall or structur
INSTALLING REAR WHEEL HOLDER
MOUNTING POSITION
OPTION A : Into solid wall (Non wood)
Hang the bike on main unit and mark the rear wheel position for rear wheel holder installation.
OPTION B : Into solid wooden wall or structure
SWING LEFT OR RIGHT TO OPTIMIZE STORAGE SPACE
LEFT
RIGHT
WARNING
- DO NOT INSTALL Swing-Up EX Bike Holder on unsupported wall surfaces, plasterboard or paneling. Make sure Swing-Up Bike Holder is mounted to a solid stud, beam, or wall. Be careful to avoid electrical, gas, or water pipes and conduits.
- The bottom wheel must have a ground clearance of 2.54cm (1”) when a bike is in the Swing-Up EX Bike Holder.
- Inspect the Swing-Up EX Bike Holder installation carefully before hanging a bike. Failure to check the mounting securely can result in possible bodily harm and bicycle damage.
- When storing a bike, ensure both wheels are properly inserted into their respective holders. Grasp your bike and carefully swing it to the side to avoid damaging wall or bike. In order to prevent damage to bike or wall, check for interference by carefully moving the bike from side to side to determine where contact with the wall is made. This should be checked with the crank rotated in different positions. Decide if you need to install appropriate wall protection to prevent damage. Topeak is not responsible for any damage that may occur when using Swing-Up EX Bike Holders.
- Swing-Up EX Bike Holder is compatible with wheel / tire combinations having an overall height of 8cm (3.15”) and tire width up to 2.6”
- Maximum weight capacity: 16kg (35lb)
WARRANTY
2-year Warranty: All mechanical components against manufacturer defects only.
Warranty Claim Requirements
To obtain warranty service, you must have your original sales receipt. Items
returned without a sales receipt will assume that the warranty begins on the
date of manufacture. All warranties will be void if the product is damaged due
to user crash, abuse, system alteration, modification, or used in any way not
intended as described in this manual. The specifications and design are
subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>