TOPEAK H220754552 Hybridmaster Mini Pump Instruction Manual

TOPEAK H220754552 Hybridmaster Mini Pump

Overview

1. Duo Fixer
2. PCT Cap (Dust cap with integrated Presta Core Tool)
3. Mounting module
4. 16g CO2 cartridge
5. Rubber band
6. C02 inflation head with air regulator
7. C02 cartridge engagement
8. Handle stopper
9. SmartHead ThreadLock inflation head with dust cap

PCT Cap (Presta Core Tool Cap): Tighten or remove two-piece Presta valve cores

DUO FIXER INSTALLATION

SADDLE COMPATIBILITY

Works with

• Standard saddle rail with 36mm spacing
• Titanium, saddle, C rails

The valve head o-ring is subject to weer and may cause air leakage over time. Periodically inspect and replace o-ring if needed.

O-ring Replacement Kit

INFLATION

Thread co, cartridge clockwise until full engagement is achieved. Be careful not to cross thread the CO2 cartridge. Hold pump body as shown to prevent twisting of the insulating cover

Push infiation head to inflate.
Turn to loosen inflation head after use

Schrader Valve

Install and thread on inflation head to the Schrader valve ****To ease inflation, you may need to hold the tube valve in place by pressing your thumb against the tire & pushing the inflation head unto the tube valve,

Pump inflation

Unscrew and pull out the hose.

Install and thread on infiation head.

Important notes

• Before inflating, make sure to move the upper handle stopper back as shown for proper operation.
• After use, make sure to move the upper handle stopper back into the upper handle to secure it.

Warning

1. If using the CO2 inflator continuously, make sure to wait 20 seconds in between cartridges for the rubber grommet inside the CO2 inflation head to return to its original position. Otherwise, a gas leak may occur and prevent proper inflation.
2. Tighten the C02 cartridge before using the C02 inflation function. Failure to do so will cause improper operation and may cause injury.
3. DO NOT remove the CO2 cartridge if it is still charged with gas. Completely discharge the C02 cartridge before removal.
4. When opening the CO2 cartridge, point the C02 inflator away from yourself and others.
5. DO NOT use CO2 Inflator if any part is cracked or broken.
6. DO NOT expose the C02 cartridge to heat, store it at temperatures above 120’F (49’C), or store in enclosed vehicles.
7. If the C02 gas does not flow smoothly, the rubber seal of the inflation head may be frozen and impede the flow of CO2 gas.
8. The barrel and CO2 cartridge may become extremely cold/ frosty when the C02 gas is expelled. DO NOT try to unscrew the C02 inflation head until it has warmed sufficiently to touch.
9. Keep out of reach of children.

After each inflation, make sure all C02 gas has been discharged by pushing the C02 inflation head several times.

The mini pump handle and C02 cartridge should be held together when pumping. DO NOT hold the C02 cartridge only!

WARNING

• Read this User’s Guide thoroughly, comply with all instructions, and understand safety information before first use.
• To avoid possibly freezing your hand, make sure to wear full finger gloves before operation.
• The CO2 cartridge contains compressed high-pressure CO2 gas.
• Incorrect operation poses a potential risk of harm to you or others nearby.
• During operation, DO NOT point the CO2 cartridge towards you or others.
• Insure that the inner tube valve is open before inflating it with a CO2 cartridge.
• Before disengaging CO2 cartridge, insure all CO2 gas has discharged.
• Failure to do so may cause bodily harm or damage to inflator head.
• Recommend to use Topeak Threaded CO2 cartridges only.

WARRANTY

2-year warranty: All mechanical components against manufacturer defects only. Warranty Claim Requirements To obtain warranty service, you must have your original sales receipt. Items returned without a sales receipt will assume that the warranty begins on the date of manufacture. All warranties will be void it the product is damaged due to user crash, abuse, system alteration, modification, or use in any way not intended as described in this manual. The specifications and design are subject tO change without notice. Please contact your Topeak dealer with any questions. For USA customer service, call: 1-800-250-3068 www.topeak.com

Co2 INFLATOR series

Recommend to use TOPEAK 25g Threaded CO2 Cartridge to inflate 27.5 plus and 29 Tires,

• Best fit tire pressure
• Actual inflation pressure may vary.

Spare parts

16g Threaded CO2 cartridge

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>