GLOBAL INDUSTRIAL 293132 36 Inch Portable Evaporative Cooler User Manual

GLOBAL INDUSTRIAL 293132 36 Inch Portable Evaporative Cooler

TECHNICAL SPECIFICATIONS

CONTROL PANEL

REMOTE CONTROLLER

KEY COMPONENTS

IMPORTANT REMINDERS

Please read the manual carefully before operating the cooler.

• A) Operating conditions:

  1.  Temperature: 18°C to 45°C; Water Temperature: < 45°C.
  2.  Power supply must not exceed the required voltage (+/-) 5%.
  3.  Air supply must be largely free of dust or extra cleaning is required.

• B) Protect the power cable from vehicle or foot traffic.

• C) Connection to incorrect electric voltage, or faulty installation will cause danger of electric shock.

• D) If the product malfunctions at startup, please disconnect from electric power immediately and refer to dealer for service.
  Other tips for cooler use:

  1. Keep doors and windows open to allow fresh air to enter, and treated air to exit, when cooler is operating.
  2.  Flashing red light on the control panel means water level in reservoir is low.
  3.  Rinse the reservoir with fresh water and clean prior to use after a period where the cooler has not been in operation.
  4. Take care when moving the cooler, especially when it is full of water. Pushing too hard will cause the cooler to overbalance and tip over, which may cause injury and will damage the cooler.
  5. To prevent buildup of algae and other biological organisms in the reservOir, regularly add chlorine/bromine tablets as per tablet manufacturer recommendation for evaporative cooler reservoirs.

OPERATING INSTRUCTIONS

WARNING

1. All electrical repairs must only be carried out by a suitably qualified electrician after all power is disconnected.
2.  This cooler is not intended for use by children.
3.  Children should be supervised to ensure that they do not play with the appliance.

MAINTENANCE

To ensure the cooler delivers fresh and clean air, regularly change the water when dirty, and clean both the dust filter and the cooling pad.

1.  Remove the filter pad by unscrewing the 4 screws on the rear of the cooler, then lift the pad and pull it out at the bottom to release. To replace the pad, slide up into the slot under the top of the cooler, push in at the bottom and allow to drop into the lower slot.
2. Clean the pad from the inner side to the outside of the pad (the inner side is towards the motor). Never use any liquid detergent. Never use pressurized water, as it may cause damage to the pad.
3.  Unscrew the drainage lid to let dirty water flow out, then clean the water tank thoroughly with a soft cloth. Wash off dirt on the water sensor, water pump and the float valve. Rinse thoroughly.
4.  Use mild soap and soft clean cloth when cleaning the cooler casing. Do not use any caustic chemical detergent that may cause damage to the surface of the cooler.
5.  To prevent the buildup of algae and biological organisms in the reservoir, regularly add chlorine/bromine tablets as per tablet manufacturer recommendation for evaporative cooler reservoirs

TROUBLESHOOTING

KEY FEATURES

Effective and Economical Energy-saving & Environmentally-friendly

• Reliable operation.
• Cools a large area.
• Quiet running.
• Adjustable speed.
• Full function remote controller.
• Large water tank for extended time between fills.
• No need for compressed air.
• No installation, no ductwork required.
• Easy to use, easy to clean.
• Body is corrosion-proof plastic.
• Easy to maintain.
• Fully portable.
• Can be attached to standard garden hose.
• Timer function for auto-start or auto-stop.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>