geemarc PhotoDECT 295 Additional Handset Phone Set User Guide
- June 5, 2024
- geemarc
Table of Contents
geemarc PhotoDECT 295 Additional Handset Phone
Introduction
Congratulations on purchasing your Geemarc PhotoDECT295 handset, offering all
the advantages of cordless technology (compliant with Digitally Enhanced
Cordless Telecommunications – DECT standard). which can be used as an
additional handset with our AMPLIDECT295 or AMPLIDECT COMBI 295 phones. This
telephone is also hearing aid compatible.
CAUTION: Use only the battery provided. There may be a risk of explosion if
the wrong type of battery is used for the parent unit. The battery cannot be
subjected to high or low extreme temperature and low air pressure at high
altitudes during use, storage or transportation. Disposal of battery into fire
or a hot oven, or mechanically crushing or cutting or the battery can result
in an explosion. Leaving the battery in an extremely high temperature
surrounding environment can result in an explosion or the leakage of flammable
liquid of gas. Battery subjected to extremely low air pressure may result in
an explosion or the leakage of flammable liquid or gas. Dispose of used
battery according to the instructions. Normal operating temperature for the
product (e.g. 0oC~40oC)
Handset
Insert Photos for speed dial keys
Pod Connection
PACKAGE CONTENTS
- 1 cordless Handset,
- 1 power adapter,
- 1 Charger,
- 1 NiMh
- battery pack,
- 1 user guide
INSTALLATION
Connect the power adapter jack to the charger then connect the power adapter plug in mains power. Use only the power adapter supplied with the phone! Connecting the battery Plug the battery connector securely into the socket inside the handset battery compartment. Insert the supplied battery as indicated. Align the cover flat against the battery compartment, and then slide it upwards until it clicks into place.
Charging the batteries
Charge the batteries for at least 16 hours when charging for the first time.
Note: DO NOT FORGET TO REGISTER YOUR HANDSET WITH DECT BASE (AMPLIDECT COMBI
295 or AMPLIDECT295).
OVERVIEW
Incoming Call light Flashes red slowly when receiving an incoming call.
-
Earpiece
-
Charger/Booster LED ( )
- – Steady red when the handset battery is charging.
- – Long flashes in red when the handset battery is low.
- – Flashes red quickly when handset registration is in progress.
- – Flashes red slowly when the handset is not registered or not in charger.
- – Steady blue when the booster function is activated.
-
Photo speed dial keys Your handset has four photo speed dial keys. It retrieves the same set of photo or Direct Memory speed dial entries stored in the AMPLIDECT295 or AMPLIDECT COMBI 295. Press to dial a preset number.
-
Talk ON / Flash ( )
Make or answer a call.- – Light Green when the handset is on earpiece mode.
- – During a call , Press to access Recall feature (R).
- TALK OFF ( )
- – Hang up a call.
- – Silence the ringer temporarily while the phone is ringing.
- – Mute the paging tone.
-
SPEAKER ( )
- – Make or answer a call using the speakerphone.
- – Switch between the speakerphone and the earpiece.
- – Light Orange when on speakerphone mode.
- Microphone
- Charging pole
- Speakerphone
- Battery compartment cover
- VOL+ ( ) – Increase the listening volume up to 30dB amplification, (Or the ringer Volume when in quiescent mode).
- Switch On/Off the receiver Booster function (LED bleu). 13. VOL- ( )
- Decrease the listening volume. (Or the ringer volume when in quiescent mode (until ringer turn OFF)).
HANDSET REGISTRATION
Base: First place the base of the AMPLIDECT295 or AMPLIDECT COMBI 295 in
Registration mode. Handset: Replace Handset in charge on Pod, the red LED
flashes quickly to indicate registration in process. You hear a confirmation
tone when the registration process completes. It takes up to 60 seconds to
complete the registration.
Note: Make this procedure if you doesn’t arrive to register your handset.
Quickly press [VOL+] [SPK] [VOL-] [SPK] [VOL+] [VOL-] [SPK] in idle mode, then
HS will have a “Bi,Bi” tone.
BOOSTER MODE
During a call, when in boost mode, you can increase the listening volume up to
30dB amplification. – Press and Hold ( 2 seconds) the VOL+ button to activate
Boost mode (LED will be steady blue). – Press and hold again the VOL+ button
to cancel Boost mode.(LED will go Off).
GUARANTEE
From the moment your Geemarc PhotoDECT295 is purchased, Geemarc guarantees it for a period of two years. During this time, all repairs or replacements (at our discretion) are free of charge. Should you experience a problem then contact our helpline or visit our website at www.geemarc.com. The guarantee does not cover accidents, negligence or breakages to any parts. The product must not be tampered with or taken apart by anyone who is not an authorized Geemarc representative. The Geemarc guarantee in no way limits your legal rights. IMPORTANT: YOUR RECEIPT IS PART OF YOUR GUARANTEE AND MUST BE RETAINED AND PRODUCED IN THE EVENT OF A WARRANTY CLAIM.
DECLARATIONS:
UKCA Directives Geemarc Telecom SA hereby declares that this PhotoDECT295 is
in compliance with the essential requirements and other relevant provisions of
the Radio Equipment Directive 2014/53/UE. The UKCA declaration of conformity
may be consulted at Electrical connection: The apparatus is designed to
operate from a 230V 50Hz supply only. (Classified as hazardous voltage
according to EN62368-1 standard). The apparatus does not incorporate an
integral power on/off switch. To switch off the apparatus, disconnect the
power adaptor. When installing the apparatus, ensure that the mains power
socket is readily accessible.
RF Parameter
Frequency| 1.88 GHz to 1.9GHz
Nb Channels| 10
RF power| < 250mW
Power Supply
Charger| Input 100-240V 50/60Hz;
Output DC6V __ 0.45A, 2.7W adapter
Handset| 2.4V,500mAH rechargeable NiMh battery pack
Recycling Directives
The WEEE (Waste Electrical and Electronic Equipment) has been put in place for
the products at the end of their useful life are recycled in the best way.
When this product is finished with, please do not put it in your domestic
waste bin. Please use one of the following
disposal options:
- Remove the batteries and deposit them in an appropriate WEEE skip. Deposit the product in an appropriate WEEE skip.
- Or, hand the old product to the retailer. If you purchase a new one, they should accept it. Thus if you respect these instructions you ensure human health and environmental protection.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>