dji Mini 3 Pro Fly More Kit User Guide
- June 5, 2024
- DJi
Table of Contents
Mini 3 Pro
Fly More Kit
User Guide
v1.0 2022.04
Carefully read this entire document and all safe and lawful practices provided before use.
A
B
DJI Mini 3 Pro Two-Way Charging Hub (Figure A)
- Status LEDs: The status LEDs display battery levels for three seconds after the batteries are inserted into the charging hub. The LEDs in an array blink successively during charging and change to solid green after the corresponding battery is fully charged.
- Function Button: Press to check the battery power level. When both the intelligent flight battery and an external device are connected for charging, the battery will be charged before the external device. Press and hold the function button for two seconds to switch the charging priority.
- Place the charging hub on a flat and stable surface when in use. Make sure the device is properly insulated to prevent fire hazards.
- DO NOT attempt to touch the metal terminals on the hub. Clean the metal terminals with a clean, dry cloth if there is any noticeable buildup.
Visit https://www.dji.com/mini-3-pro/downloads and refer to the DJITM Mini 3 Pro User Manual for more information.
Specifications
| Model Number | CHX162-30 |
|---|---|
| Supported Charger | USB Power Delivery charger |
| Input (USB-C) | 5 V 3 A, 9 V 3 A, 12 V 3 A |
| Output (USB) | 5V 2A |
| Operating Temperature | 5° to 40° C (41° to 104° F) |
DJI Mini 3 Pro Propellers (Figure B)
- Mount the marked propellers to the marked motors and the unmarked propellers to the unmarked motors.
- Use the screwdriver provided in the aircraft package to remove and install the screws. Unsuitable screwdrivers may damage the screws.
- Use the new screws provided with the propellers when installing. DO NOT reuse old screws.
- Use two propellers from the same package. DO NOT mix with propellers from other packages.
DJI Mini 3 Pro Intelligent Flight Battery
Specifications
| Model Number | BWX162-2453-7.38 |
|---|---|
| Capacity | 2453 mAh |
| Max Charging Power | 37 W |
| Battery Type | Li-ion |
| Chemical System | LiNiMnCoO2 |
| Charging Temperature | 5° to 40° C (41° to 104° F) |
Compliance Information
FCC Compliance Statement: Supplier’s Declaration of Conformity
Product name: DJI Mini 3 Pro Two-Way Charging Hub
Model Number: CHX162-30
Responsible Party: DJI Technology, Inc.
Responsible Party Address: 201 S. Victory Blvd., Burbank, CA 91502
Website: www.dji.com
We, DJI Technology, Inc., being the responsible party, declares that the
above mentioned model was tested to demonstrate complying with all applicable
FCC rules and regulations.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
CAN ICES-003 (B) / NMB-003(B)
EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device (CHX162-30) is in compliance with the essential requirements and other relevant provisions of the Directive 2014/30/EU. A copy of the EU Declaration of Conformity is available online at www.dji.com/eurocompliance EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device (CHX162-30) is in compliance with the essential requirements and other relevant provisions of Electromagnetic Compatibility Regulations 2016. A copy of the GB Declaration of Conformity is available online at www.dji.com/eurocompliance
Environmentally-friendly disposal
Old electrical appliances must not be disposed of together with the residual
waste, but have to be disposed of separately. The disposal at the communal
collecting point via private persons is for free. The owner of old appliances
is responsible to bring the appliances to these collecting points or to
similar collection points. With this little personal effort, you contribute to
recycle valuable raw materials and the treatment of toxic substances.
EU Compliance Statement:
SZ DJI TECHNOLOGY CO.,LTD. hereby declares that this device (BWX162-2453-7.38)
is in compliance with the essential requirements and other relevant provisions
of the Directive 2006/66/EC,2014/30/EU A copy of the EU Declaration of
Conformity is available online at
www.dji.com/eurocompliance EU contact
address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
Compliance Statement:
SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device
(BWX162-2453-7.38) is in compliance with the essential requirements and other
relevant provisions of The Batteries and Accumulators (Placing on the Market)
Regulations 2008 (as amended) and the Waste Batteries and Accumulators
Regulations 2009 (as amended) A copy of the GB Declaration of Conformity is
available online at
www.dji.com/eurocompliance.
WE ARE HERE FOR YOU
https://www.dji.com/support
Contact DJI SUPPORT
http://weixin.qq.com/q/02flVqYu_2eF410000003a
https://www.dji.com/mini-3-pro/downloads
is a trademark of DJI.
USB-C is a registered trademark of USB Implementers Forum.
Copyright © 2022 DJI All Rights Reserved.
YCBZSS00181504
Documents / Resources
| dji
Mini 3 Pro Fly More
Kit
[pdf] User Guide
Mini 3 Pro, Fly More Kit, Mini 3 Pro Fly More Kit
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>