HUGHES 4510 Satellite/Cellular Terminal User Guide
- June 5, 2024
- Hughes
Table of Contents
Hughes 4510 Quick Start Guide
The intent of this guide is to acquaint the user with the Hughes 4510 terminal and power it up.
-
Unpack the box. Without tearing the plastic over the 4510, lift it out of the box, unfold the flaps, and slide it out of the sleeve. Save the box and packing material should you need to ship the 4510 at a later time.
-
Satellite and Cellular SIMs
a) Remove the SIM door
b) Insert the satellite SIM card supplied by your service provider in the SAT SIM slot
c) Most users will be using the integrated eSIM, so no further action
Note: If using a third-party cellular service, the insertable cellular SIM should be used
– Insert the cellular SIM card supplied by your service provider in the CELL SIM holder provided
– Insert the CELL SIM holder into the CELL SIM slot. These slots can be seen in the graphic below
-
Connect a Hughes cable (3501314-000x) from the barrel connector to power and Ethernet using the cable pinout table below.
Pin
| Wire Color|
Function
---|---|---
1| White
| Remote Switch/Ignition
2| Black
| Ground
3| Red| Power +12VDC
la| Green| Ethernet RX-
2a| White/Green| Ethernet RX+
3a| Orange| Ethernet TX-
4| White/Orange| Ethernet TX+
5| Yellow| GPIO (for future use)
Regulatory and safety information is provided in the user manual which can be downloaded from the website http://echostarmobile.com
-
Ensure that the red wire is connected to always-on 12VDC and that the white wire is connected to switched power (e.g., vehicle ignition) to power the 4510 on and off automatically, there is no power button on the terminal.
Note: The power supply must be rated for a maximum peak current of 3.5 A at 12V. -
After powering up the 4510 will attempt to establish a Cellular connection with the integrated Echostar Mobile eSIM. The LED states are provided in the table below.
State| LED
---|---
Powering up| Solid GREEN
Network acquisition| GREEN flashing
Registered and IP context active| Solid GREEN
Hardware fault| Solid RED -
Connect the 4510 to your computer via Ethernet or the USB port under the SIM door. Open a web browser and enter the address 192.168.128.100 (Ethernet) or 169.254.1.1 (USB) to access the home page of the UT Web User Interface.
-
The many configuration options are documented in the 4510 User Guide which can be downloaded from http://echostarmobile.com.
3004405-0001 Rev.B
Documents / Resources
|
HUGHES 4510 Satellite/Cellular
Terminal
[pdf] User Guide
4510, Satellite Terminal, Cellular Terminal
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>