HUGHES AUTOFORMERS PWD30 EPO, 30 Amp Spike Power Watchdog Installation Guide
- June 4, 2024
- HUGHES AUTOFORMERS
Table of Contents
HUGHES AUTOFORMERS PWD30 EPO, 30 Amp Spike Power Watchdog
INSTALLATION INSTRUCTIONS
-
Step one:
Loosen and unscrew the top and bottom cable gland connectors -
Step two:
Unscrew the 8 Phillips screws(M3*16) on the back side of the unit
-
Ste p three:
Carefully separate the top and bottom halves of the Power Watchdog Unit. -
Step four:
Unclip the connections. Take note of where these connections come from. -
Step five:
Unscrew the 3 phillips screws.Holding down the surge board. -
Step six:
Place in the new surge module，rescrew the 3 screws, clip together the wire connections.
-
Step seven:
Place top and bottom halves together, rescrew all the screws, tighten down the cable gland connectors. *Do not overtighten the screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>