VINZ Motorcycle Cover for Indoor and Outdoor Instruction Manual
- June 5, 2024
- VINZ
Table of Contents
VINZ Motorcycle Cover for Indoor and Outdoor
INSTRUCTIONS
- Unfold the motorcycle cover and open the buckle.
- Place the motorcycle cover over the two-wheeler and make sure that the corners slide over the two-wheeler.
- Attach the buckle under the two-wheeler.
- There are holes on the front and back, so that a lock can be attached.
MAINTENANCE
Only clean the cover with clean, tepid water. Never use laundry detergent or
other cleaning agents. After cleaning the product, hang the cover
to dry.Let the cover dry properly before it is folded, packed and stored away.
WARRANTY
Bisshops BV offers a manufacturer’s warranty of 1 year from the date of
purchase. This warranty guarantees that the product meets the standards of
usability, reliability and durability.
The warranty does not apply to:
- Damage resulting from failure to observe this user manual.
- Personal injury or material damage caused by improper use or failure to observe the safety instructions.
- Damage as a result of changes or repairs (by third parties), without written permission from Bisshops.
WARNINGS
-
Make sure the two-wheeler is clean (dust- and dirt-free) before using the protective cover, so that no scratches can be made.
-
Only use the protective cover when the two-wheeler has cooled down completely. Otherwise both the cover and two-wheeler can be damaged and there is a risk of fire hazard.
-
The cover is not suitable for protecting the two-wheeler during transport on, for example, a trailer.
-
Do not use the protective cover if the two-wheeler has been treated with a spray for corrosion protection. Chemical reactions can occur that can damage both the two-wheeler and the cover. Therefore avoid contact between
the protective cover and surfaces treated with anti-corrosion spray. -
. Do not use the protective cover with two-wheelers that have just been painted, sealed or treated chemically. The commonly used solvents can still evaporate up to six months after application, which can damage both the cover and two-wheeler. Take this into account, especially for new vehicles.
-
A covered two-wheeler has a larger surface area than a non-covered two-wheeler, and will therefore is considerably more susceptible to wind. Strong inds can easily overturn the two-wheeler.
-
When covering the two-wheeler, pay attention to sharp edges and corners on the vehicle so that the cover does not tear.
-
Do not use the protective cover on a wet two-wheeler, to prevent corrosion.
-
Remove the protective cover regularly for prolonged use to prevent corrosion.
-
Make sure that the cover does not touch the ground, even if the vehicle is dry. This guarantees an air circulation that reduces moisture.
-
Avoid prolonged exposure to the sun and place the covered two-wheeler in the shade as much as possible. With long-term exposure to the sun, the structure of the cover will change and there is a risk of condensation forming between the two-wheeler and the cover.
-
Keep the cover away from children to avoid the risk of choking (while playing)