BEAM All-In-One Classroom Audio Enhancement System User Guide
- June 5, 2024
- AUDIO ENHANCEMENT
Table of Contents
BEAM
Quick Start Guide
BEAM Front
BEAM LED Status Indicators visible through the front grille
BEAM Rear
Optional Wall Mount Attachment Points
Inputs and Controls
Install BEAM into Power Base
- The BEAM Can be used vertically or horizontally in the power base
- Insert the BEAM
- Plug the power connection from the base into the back of the BEAM
Pairing Microphones to the BEAM
Check to see if your microphone is paired by turning on your Teacher/Lanyard
and Handheld Microphones (Teacher/Lanyard Mic: press PWR for 1 second;
Handheld Mic: flip TALK switch up). If the LED under the BATT indicator turns
green, the mic is paired. If the LED blinks another color (orange), then turn
off your microphones and use the following instructions to pair them to the
BEAM.
Teacher/Lanyard Microphone Pairing
Turn mic off: press and hold PWR/MUTE until the green BATT light turns off.
Press and release the XD LINK button on the side of the BEAM.
Press and hold the PWR/MUTE and REC buttons simultaneously on the Teacher/
Lanyard Microphone until a beep is heard from the BEAM.
Handheld Microphone Pairing
Turn mic off: flip the TALK switch down. The green BATT light will turn off.
Press and release the XD LINK button on the side of the BEAM.
Press and hold the PWR/LINK button and TALK pushbuttons simultaneously on the
Handheld Microphone until a beep is heard from the BEAM.
www.AudioEnhancement.com
800.383.9362
DC-40884.01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>