GIVINGTREE B10112 Non Electric Bidet Toilet Attachment Self Cleaning Dual Nozzle Instruction Manual
- October 30, 2023
- GIVINGTREE
Table of Contents
GIVINGTREE B10112 Non Electric Bidet Toilet Attachment Self Cleaning Dual
Nozzle
Product Information
Product Models: B10221, B10121, B10122, B10211, B10111, B10112
Product Introduction
- Functional Control Knob: Used to control the water pressure during washing.
- Water Temperature Control Knob: Used to adjust the water temperature during washing.
- Adjustable Assembly Panel: Can be adjusted to fit different toilet sizes and shapes.
- Temperature Display: Displays the current water temperature.
- Front washing: Used for front washing.
- Rear washing: Used for rear washing.
Control Knob Operation
- OFF: Turns off the bidet.
- Nozzle Clean: Cleans the bidet nozzle.
- Front washing: Activates front washing mode.
- Rear washing: Activates rear washing mode.
Accessories
- T-Adapter
- Flexible hose
- Tube
Product Usage Instruction
Installation Tools Needed
- Wrench
- Washer
- Screwdriver
- Battery
Battery installation
- Open the battery cover.
- Insert the battery into the battery compartment.
- Close the battery cover.
Installation Instructions
- Turn off the water supply and flush the toilet to drain the tank.
- Remove the toilet seat.
- Install the bidet according to the manufacturer’s instructions.
- Install the toilet seat.
- Connect the cold water supply to the bidet.
- Connect hot water to the bidet (if available).
Q &A
-
Q: When the Bidet is opened and no water is sprayed, what should I do?
A: Check whether the water supply valve is open. -
Q: When the cleaner is turned on and the water is not directed directly in front of me, what should I do?
A: Move the body of the cleaner from left to right so that it can be installed straight and the nozzle can be positioned in the middle to the front. -
Q: When the cleaner is turned on, the water flows straight down, not up. What should I do?
A: There is no issue with the bidet. This is normal operation.
Product Models:
- B10221
- B10211
- B10121
- B10111
- B10122
- B10112
Product Introduction
Control Knob Operation
Accessories
Tools Needed
Battery installation
INSTALLATION
- Turn off the water supply, flush the toilet to drain the tank
- Remove toilet seat
- Install bidet
- Install the toilet seat
- Connect cold water supply to bidet
- Connect Hot water
Q&A
- When the Bidet is opened and no water is sprayed, check whether the water supply valve is open.
- When the cleaner is turned on and the water is not directed directly in front of you. The body of the body cleaner can be moved from left to right so that the body cleaner can be installed straight and the nozzle can be positioned in the middle to the front.
- When the cleaner is turned on, the water flows straight down, not up.
- Check whether the nozzle is blocked by the inner wall of the toilet when it extends down.
- Check whether the installation of the body cleaner is too close to the inside of the toilet, causing the nozzle to extend down and interfere with the toilet wall.
- When the connection leaks.
- Check whether the thread specification of the inlet pipe matches the tee thread specification.
- Check whether the fitting thread connected to our tee is broken. If it is broken, please replace the fitting yourself.
- Check whether there is a sealing gasket installed at the leaking joint.
- If, in the end, you are still struggling with the above questions, please contact us.
Warning: Do not flush the toilet while using the cleaner!