wopet D100 WIFI Pet Camera Treat User Manual

wopet D100 WIFI Pet Camera Treat

Product Specifications

• Model: D100
• Food size: 2-15mm (dry food only)
• Product size: L147147254mm/5.785.7810in
• Product weight: 1.1kg/2.42lbs
• Product material: ABS
• DC-powered supply: 5V/1A
• Network: 5GHz/2.4GHz

Product Usage Instructions

Features and Indicators

• Lid
• Status Light
• Set Button & Manual Feeding
• HD Camera Microphone
• Treat Popper
• 300-Degree Rotating Holder
• USB Port

WIFI Requirements

To optimize equipment performance, it’s best to use it within 10m of a WIFI transmitting device in a barrier-free environment.

App Installation

Download and install the APP by scanning the QR code below. For Android users, search ‘women smart’ in the Google Play store. For iOS users, search ‘WOPET’ in the App Store.

App Usage

Step 1: Add the Pet Camera Treat

• Launch the Wopet App, then register an account and log in. Add a named D100 device to your account.

Step 2: Access the WLAN Network

• Press and hold the button until you hear a Ding-Dong sound. Wait for the indicator to blink green before proceeding.

Step 3: WLAN Connection Modes – Bluetooth Mode (Recommended)

• Select Bluetooth Mode and follow the on-screen prompts to connect to WIFI from your phone.

App Interface Function Introduction

• You can capture photos, enable voice chat, adjust settings, and toss treats to your pet using the app interface.

Switching Different Mode

FAQ

Q: What should I do if Bluetooth mode fails during setup?

A: If Bluetooth mode fails, please refer to the Scan mode or AP mode guide on and off the user manual for alternative setup options.

Product Specifications

Features and Indicators

WIFI Requirements

In order to optimize equipment performance, it’s best to use it within 10m of a WIFI transmitting device in a barrier-free environment.

App Installation

• Download and install the APP by scanning the QR code below.
• For Andriod users, search “wopet smart” in the Google Play store, For IOS users, search”WOPET” in the App Store.
• Scan the QR code to download the WOPET APP

App Usage

1. Step 1 Add the Pet Camera Treat
   • Launch the “Wopet” App, then register an account and log in.
   • Note: Each device can be attached to only one account at a time, but one account can have up to three devices connected.
   • Choose the + option to add a named D100 device.
   • Note: Make sure your phone is connected to WIFI with favorable network speeds.
2. STEP 2 Access the WLAN Network
   • Press and hold the SET button, then release it when the device makes a “Ding-Dong” sound. It will then display “restore successfully” which means the machine has been reset.
   • Note: Observe and wait for the indicator to blink green before selecting the connection mode in the next step
3. STEP 3 WLAN Connection Modes
   • Step 3.1 Bluetooth Mode Recommended
   • Choose “Bluetooth Mode.”In the next step, a pop-up will prompt you to then turn on Bluetooth as in the description
   • The app will automatically access WIFI from your phone; just type the correct password. Finally, click the “confirm” option and it will begin connecting.
   • Note: If Bluetooth mode fails, please refer to the Scan mode or AP mode guide on and.

App Interface Function Introduction

• Note: Press and hold the “Toss a treat” button to toss up a treat
• On this page, you can take a photo or video of your cute pet, and they are saved in the “Gallery” section.
• You can set voice interaction with your pet using “Voice Chat” and “Sound” options.
• Click in the top right corner to enter the settings interface.
• You can set the device name, recording, volume, etc.
• If you want to have voice interaction with your pet, you must enable the “Two-way voice” option.
• If the device is lacking food, you can check this notification in the “Event List” option.
• Click Me” in the bottom right corner to enter the settings interface.
• Select the “Push” option, and you can receive a push notification when feeding is complete.
• You can also change your password on this page.
• Check the updates
• Close the account
• Log out the account
• If there is a question about your device, please click “help” and enter the next page below.
• Please refer to this page for solutions. For any other questions, please contact customer service via support@wopet.com .

Switching Different Mode

• If the Bluetooth mode connection fails: Press and hold the “SET” button, then release it when the device makes a “Ding” sound. Wait for the indicator to slowly blink green, and then select one of the modes.

1. STEP 1 Scan Mode
   • In the next step, type the corresponding password, and a QR code” will appear. Aim the camera on the device towards the code until it makes a ”DI“ sound, and wait for the connection.
2. STEP 2 Ap Mode
   • In the next step, type the corresponding password, then open your phone’s “WLAN” settings page. Find and connect to the WIFI network starting with “Wopet_xxx”. Finally, go back to the app.

Rotating 300-Degree Views

• When first plugging the cable, the holder will automatically rotate 300 degrees.
• You can press the” rotate the angle” button to rotate either angle to adjust the angle of the camera.

Manual Feed

• Tap the button to manually pop a treat.

FAQs

When pressing the Toss a treat button the dog food or snack is tossed two or three times.

If the sensor lamp doesn't detect the food, it will be tossed again and maybe tossed up to four times.

APP has displayed the prompt for Dispense excessive food

The snack outlet is blocked; please remove the blockage and clean it.

APP has displayed the prompt of No Food

The equipment doesn’t sense any fodder in the bucket. Check if the grain bucket has fodder in it; or if the equipment is exposed to direct sunlight, please move it to a cooler place.

The video stream is choppy and or buffering frequently

Check if the WIFI signal is strong enough, and try to refresh the page on the app.

The user can't enter his her APP account.

Please check that you are properly connected to the network Ensure the account isn't currently being used by another user

Any more questions, please email our support team: support@wopet.com

FCC Warnings

Changes or modifications to this unit are not expressly approved. Non- compliance could void the user’s authority to operate the equipment.
Notes: This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur with any particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a different circuit from that to which the receiver is currently connected.
• Consult the dealer or an experienced radio / TV technician for help.

Shielded interface cables must be used with the equipment to comply with the limits for a digital device according to Subpart B of Part 15 of FCC Rules.
Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.

Warranty Information

1. NON-TRANSFERRABLE LIMITED WARRANTY
2. To provide customers with a quality shopping and user experience, we guarantee to replace, issue a refund, and provide acceptable solutions to any defective products (as the customers prefer) from the date of purchase up to 2 years.
3. Proof of purchase must be provided (order number or receipt) when claiming our customer support center.
4. Warranty registration may be requested within a month from the date of purchase, by sending your order number to the mailbox: support@wopet.com
5. The warranty is not transferable. We only provide warranty services to buyers who purchased from our Amazon store and WOpet official website store and possess proof of purchase -not to any other purchaser or subsequent owner.
6. Price price-matching policy is not applicable. No price difference will be refunded.
7. The sellers are the responsible party. Amazon allows different sellers to sell the same product, so please confirm the seller by checking the order details before contacting us.
8. WHAT IS COVERED
   • Receiving defective or used (proof needed) products;
   • Receiving with missing parts;
   • Item is defective under proper use.
9. WHAT IS NOT COVERED
   • Purchase from non-amazon channels /non-WOpet official website store/other physical stores;
   • Gift without proof of purchase;
   • Tampering/abnormal use/accidental damage;
   • Replacements and parts;
   • Installation fee/labor fee;
10. MAKING A CLAIM
    • If you have any problems when using our products, please send an email to the mailbox: support@wopet.com 30 days free Return & Replacement
    • Standard Warranty: 1-Year product Warranty 2-Year Warranty
    • Application: Please scan the QR code below to finish the registration form on our official website to get a 2-year total warranty.
    • Note Please finish the form within 30 days after you receive the items.

Have a Question?

1. Find your order
2. Click “View order details
3. Click the Seller name
4. Click “Ask a question

• Gifted parts, replacements, and consumable products are not covered by the 2-year warranty
• Manufactures’ warranties may not apply in all cases, depending on factors such as the use of the product, where the product was purchased, or who you purchased the product from.
• Please review the warranty carefully, and contact the manufacturer if you have any questions.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>