sOmfy 5166656 Tahoma Switch Box for Home Automation Intelligent Control Instructions
- June 5, 2024
- somfy
Table of Contents
5158777B
Easy setup
-
Scan with your phone to download the TaHoma app.
https://tahoma-app.somfy.com/ -
Follow the instructions on TaHoma app.
Note: For TaHoma Switch 5166656
There are no instructions on the functioning of the product because the user
is guided through all the steps in its android/apple app. A simple leaflet is
provided to tell the user to download the app. The printed user manual only
contains safety and important/mandatory instructions as below:
Please read these safety instructions before installing and using the TaHoma.
These instructions must be kept by the user of the TaHoma. In addition to the
following instructions given in this guide, the instructions detailed in the
installation and user guides available at
www.somfy.com must be observed. Failure to follow
these instructions or the use of the TaHoma outside the field of application
defined in these instructions is forbidden and will invalidate the warranty
and discharge Somfy of all liability. Before installation, check that the
TaHoma is compatible with the associated equipment and accessories. If in
doubt when installing the TaHoma, and/or to obtain additional information,
contact a Somfy adviser or visit www.somfy.com.
Electrical connection
Only use the mains adapter supplied with the TaHoma to connect to the mains. The main adapter must be connected to an electrical system in good condition and compliant with applicable standards. Make sure the power supply voltage and frequency indicated on the mains adapter data plate match those of your electrical installation. Unwind the electric cable fully before connecting it to the socket to avoid overheating. Always hold the adapter unit when connecting and disconnecting the mains adapter. Never pull on the cables. Never touch the mains adapter with damp or wet hands, as this could cause electrocution. The mains adapter and its cable must be kept out of the reach of children and away from pets while remaining accessible so that it can be disconnected quickly in case of emergency.
General Instructions
To avoid damaging the product, do not knock or drop it, splash it, or expose
it to flammable materials or sources of heat or moisture. Do not place any
object containing liquid on the appliance.
Do not open the appliance. Do not drill holes in it. Do not attempt to repair
it.
Do not install or use it outdoors, and do not run the cable outdoors.
Maintenance
Do not use abrasive products or solvents to clean it. Use a soft, dry cloth to clean its surface.
| Model name and reference | TaHoma switch |
|---|---|
| Operating temperature | 32°F – 95°F (0°C – 35°C) |
| Power supply | 5VDC — 2A |
| Frequency used and maximum radiated power |
- 433.050 MHz – 434.790 MHz — ERP <10 mW
- 2.400 – 2.4835 GHz – ERP <1000 mW
FCC and INDUSTRY CANADA
RF Radiation Exposure Statement: This equipment complies with FCC and Industry
Canada RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20
centimeters between the antenna and all persons.
INDUSTRY CANADA
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the
equivalent isotopically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
CAN ICES-3(B)/NMB-3(B)
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
FCC STATEMENTS
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. -
Consult the dealer or an experienced radio/TV technician for help.
Caution: the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>