IPGARD DPMST-4S Secure 4-Port Single Head DP to 2 x HDMI Switch User Guide
- June 5, 2024
- iPGARD
Table of Contents
IPGARD DPMST-4S Secure 4-Port Single Head DP to 2 x HDMI Switch User Guide
Quick Start Guide
A full manual can be downloaded from
www.ipgard.com/documentation/
WHAT’S IN THE BOX
NOTICE
The information contained in this document is subject to change without notice. iPGARD makes no warranty of any kind with regard to this material, including but not limited to, implied warranties of merchantability and fitness for a particular purpose. iPGARD will not be liable for errors contained herein, or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent from iPGARD, Inc.
TECHNICAL SPECIFICATIONS
EDID LEARN
The KVM switch is designed to learn a connected monitor’s EDID upon power up.
In the event of connecting a new monitor to the KVM a power recycle is
required.
The KVM switch will indicate the unit’s EDID learn process is active by
flashing the front panel’s LEDs in sequential order.
Starting with the LED above button “1” on the front panel, each LED will flash
green for approximately 10 seconds upon beginning
the EDID learn. Once all the LEDs stop flashing, the LEDs will cycle and the
EDID learn will be complete.
If the KVM switch has more than one video board (such as dual-head and quad-
head models), then the unit will continue to learn the EDIDs of the connected
monitors and indicate the progress of the process by flashing the next port
selection green and blue push-button LEDs respectively.
A monitor must be connected to the video output port located in the console
space at the back of the KVM switch during the EDID learn process.
If the read EDID from the connected monitor is identical to the current stored
EDID in the KVM switch, then the EDID learn function will be skipped.
HARDWARE INSTALLATION
- Ensure that power is turned off or disconnected from the unit and the computers.
- Use Dispay Port cables to connect the Display Port output ports from each computer to the corresponding Display Port in ports of the unit.
- Use a USB cable (Type-A to Type-B) to connect a USB port on each computer to the respective USB ports of the unit.
- Optionally, connect a stereo audio cable (3.5 mm to 3.5 mm) to connect the audio output of the computer(s) to the audio in ports of the unit.
- Connect monitor(s) to the HDMI out console ports of the unit using HDMI cable(s).
- Connect a USB keyboard and mouse in the two USB console ports.
- Optionally, connect stereo speakers to the audio out port of the unit.
- Finally, power on the secure KVM switch by connecting a 12-VDC power supply to the power connector, and then turn on all the computers.
Note : You can connect two monitors to the single-head KVM switch and four monitors to the dual-head KVM switch. The computer connected to port 1 will always be selected by default after power up.
DESIGNED AND MADE IN THE USA
Toll Free: (888)-994-7427
Phone: 702-800-0005
Fax: (702)-441-5590
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>