FIAMMA F80s Ducato Roof Mounted Campervan Motorhome Wind out Awning Instruction Manual
- June 5, 2024
- FIAMMA
Table of Contents
FIAMMA F80s Ducato Roof Mounted Campervan Motorhome Wind out Awning
Package contents
**Seal
**
Check that nothing has been damaged or deformed during transport. In the event of doubts or questions concerning the installation, use or limitations of the product, contact the dealer. We recommend that the installation is carried out by qualifi ed personnel and in compliance with current local regulations.
ATTENTION: INSTALLATION ON FIXING KIT
The awnings are to be fi xed on the brackets so that the words “SUPPORT” on the
awning are in correspondence of the brackets: this condition is necessary and
indispensable for the two brackets situated at the extremities (which are
located on the fi xing point of the arms on the case-box). It is important, but
not indispensable, for the central bracket/s as it/they provide/s only a
mounting support. The brackets must always be well-aligned to each other to
avoid later problems; in case they are not, they must be properly shimmed
using the spacers to ensure the alignment. The installation of the awning can
occur only when the brackets are perfectly aligned to the roof of the vehicle.
Installation instructions
Left-hand drive
Right-hand drive
Attention: to fix the brackets, use exclusively the hooks that are on the vehicle.
Important: use of SIKA 252 adhesive is essential for fi xing the bracket (brackets).
Attention Security: Remove this label only after fi xing the awning on the adapter.
When using the awning please follow the instructions of the product.
ATTENTION: Periodically check the brackets to make sure they are firmly attached (especially after the fi rst kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
Safety instructions
Read the following instructions and warnings carefully; failure to observe these installation and usage instructions as well as the laws for driving in the relevant country may cause severe harm or damage for which the manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the product must be installed. Checking that the wall/roof/rear door is sufficiently solid and suitable for guaranteeing the resistance of the anchoring points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions are not guaranteed and it will be necessary to reinforce it these points. In the event of an accident involving the vehicle and/or the product, ensure that the product has not been damaged. In the event of damage, contact your local retailer before moving the vehicle. Fiamma declines every responsibility for any modifi cation of the product that may cause damage and/or injury to things and people.
Warranty
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer
is entitled to the warranty in accordance with local laws and regulations of
the country in which the product was purchased.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>