Skullcandy Jib True Wireless In-Ear Headphones User Guide

: June 5, 2024
: Skullcandy

Skullcandy Jib True Wireless In-Ear Headphones User Guide

Auto Pair Mode

Pairing Mode

Auto Power – on

Power – on

Auto Power – Off

Power – off

Charge Earbuds

Charge Earbuds

Charge Case

Charge Case

Charge Case Battery Life

Check battery Life

1 Flash = Low Battery
2 Flash = Medium Battery
3 Flash = High Battery

Pairing Mode

Pairing Mode

Left Side or Right Side
On Mode
Not Connected To Device

left Side or Right Side
Off Mode

Pair New Device

Pair New Device

“Jib True”
Left Side or Right Side

Power – On

Power – On

Left Side and Right Side

Power – Off

Power – Off

Left Side and Right Side

Play/Pause

Play/Pause

Left Side or Right Side

Track Forward

Track Forward

Right Side

Track back

Track back

Left Side

Volume Up

Volume Up

Right Side

Volume Down

Volume Down

Left Side

Answer/End

Answer/End

Left Side or Right Side

Activate Voice Assistant

Activate Voice Assistant

Clear Paired Device

Reset Device

Questions Visit: www.skullcandy.com

Speaker Driver: 6mm,
Impedance: 22 Ohms, THD <3%@1 KHz,
Voltage Regulation: 5V, 500mA, Bluetooth® 5.0,
Frequency Band: 2402MHz — 2480MHz,
Maximum Power: 10mw,
Weight: 63.5g.

Maximum operating temperature 45°C.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

ISED Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1 )This device may not cause interference.(2)This device must accept any interference, including interference that may cause undesired operation of the device.

ISED SAR Compliance Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

Americas
Skullcandy, Inc.
6301 N Landmark Dr. Park City, UT 84098 U.S.A.
Skullcandy.com

Contains Li-ion battery. Battery must be recycled or disposed of properly.

Hardware Version: VO4 (Earbud)/ V6.0 (Charging case)
Software Version: V0.95 (Earbud)/ V2.0.9957 (Charging case)

Made in China.

Jib True
MODEL: S2JTW
FCC ID: Y22-S2JTW
IC: 10486A-S2EW

R-C-Sku-S21f1A,