KLARSTEIN 10033614 ORFEO Tabletop Gas Barbecue Instruction Manual

: June 5, 2024
: Klarstein

Table of Contents

KLARSTEIN 10033614 ORFEO Tabletop Gas Barbecue
ASSEMBLY
INSTRUCTIONS FOR USE
CLEANING AND CARE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KLARSTEIN 10033614 ORFEO Tabletop Gas Barbecue

SAFETY INSTRUCTIONS

Read the following instructions carefully and be sure your barbecue is properly installed, assembled and cared for. Failure to follow these instructions may result in serious bodily injury and/or propert y damage. If you have any questions concerning assembly or operation, consult your dealer or LPG Company. Never place the cylinder directly next the barbecue. Always place the cylinder to the left hand rear side of the appliance. The cylinder should be kep as far away from the appliance as possible without straining the hose. Never light the grill with the lid closed. The appliance and cylinder must be placed on level surface and must not be used while lit.

When the wind speed is above 2m/s, don’t use gas grill facing to the wind.
The appliance is designed for use outdoors only.
Warning! Accessible parts may be very hot. Keep young children away.
Read the instructions before using the appliance.
Do not move the appliance while in use.
Turn off the appliance at the cylinder valve or regulator after use.
Any modification to the appliance may be dangerous and may cause injury or propert y damage.
The parts sealed by the manufacturer or his agent shall not be manipulated by the user.
Any unauthorised modification of the appliance will invalidate the guarantee on this appliance.
Do not modify the appliance.
Never mount the cylinder under the barbecue on the base shelf as this could result in serious injury to the user, other people and/or propert y.
Use protective gloves when handling particularly hot components.
There must not be any overhead obstructions, such as trees, shrubs or lean-to roofs, above the appliance. The appliance must be installed with a clearance of 1 m around all sides.
The appliance must not be used near flammable materials (petroleum based products, thinners or any other solid object that carries a flammable warning label.)
Close the valve of the gas cylinder or the regulator after use.
The use of this appliance in enclosed areas can be dangerous and is PROHIBITED.

ASSEMBLY

INSTRUCTIONS FOR USE

Follow these instructions carefully to avoid seriously damaging your barbecue and causing injury to yourself and to property.

Assemble the barbecue following the assembly instructions carefully.
Connect the gas hose to the barbecue. Connect the regulator to the hose.
Connect the regulator to the cylinder valve following the regulator instructions supplied with the regulator.
Turn all of the control knobs to the ‘OFF’ position before turning on the gas supply to the appliance.
Operate the regulator in accordance with the instructions supplied with the regulator.

Lighting your barbecue

Warning

Risk of fire

Before attempting to light your gas grill you must refer to your lighting instructions and warning / safety points. Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is found to be faulty in any way do not attempt to use your gas grill. When changing your gas bottle, ensure that no sources of ignition, such as fires, cigarettes, naked flames, etc., are in the area. Make sure that the appliance is switched off.

Connect the gas cylinder to the barbecue following the instructions supplied with the regulator.
Turn all the control knobs to the ‘OFF’ position.
Turn ‘ON’ the gas supply at the cylinder or regulator switch following the regulator connection and operating instructions. With soapy water, check for any gas leakage between the bottle and the regulator and the gas valve. Any leakage will show as bubbles in the area of the leak. If leak is found do not use the barbecue. Consult your gas or barbecue supplier for advice.
To light the left hand burner, push down the left hand control knob and keep pressing while turning anticlockwise to the “full rate” position whilst press the ignition button sited between the two knobs up to four times in rapid succession. This will light the left hand burner. If not please repeat this process.
If the burner has not lit after two attempts, turn ‘OFF’ the gas tap and wait 5 minutes before retrying the ignition sequence.
If the burner does not stay alight, please repeat step 4.
When the burner is lit. Adjust the heat by turning the knob to the High/Low position.
To light the right hand burner, push down the right hand control knob and keep pressing whilst turning anti-clockwise to the “full rate” position whilst press the ignition button sited between the two knobs up to four times in rapid succession. This will light the right hand burner. If not please repeat this process.
If the burner has not lit after two attempts, turn ‘OFF’ the gas tap and wait 5 minutes before retrying the ignition sequence.
If the burner does not stay alight, please repeat step 8.
When the burner is lit, adjust the heat by turning the knob to the High/Low position.
To turn ‘OFF’ the barbecue, turn the cylinder valve or regulator switch to the ‘OFF’ position by following the regulator instructions. Turn all of the control knobs on the appliance clockwise to the “OFF” position when the flames have extinguished.

Warning

Risk of Burns

If any burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off. Wait five minutes before attempting to relight with ignition sequence.

After use, close the gas supply by either turning ‘OFF’ the switch on the regulator or turning ‘OFF’ the cylinder valve.

In the event of light going out while the appliance is in use: turn all the controls, cylinder valve and regulator switch to the ‘OFF’ position. Wait 5 minutes before attempting to relight the appliance. If the problem persists after relighting, consult your gas dealer, or the store where you purchased the barbecue, or a qualified gas engineer for assistance or repair. Never try to rectify the problem yourself as this could result in serious injury and/or propert y damage.

Clean the appliance of excess fat, before storage, with a damp cloth using a mild detergent solution as the cleaning agent. Store the appliance in a clean dry environment. Do not store your gas cylinder indoors. Store in a well ventilated area away from direct sunlight.

To check for leaks

Make 2-3 fluid ounces of leak-detecting solution by mixing one part dish soap liquid with 3 parts water.
Ensure the control valve is ‘OFF’.
Connect the regulator to the cylinder and connect regulator with hose and outdoor gas grill. Ensure the connections are secure then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which must be rectified before use. Turn off the gas supply in the event of gas leak.
Retest after fixing the fault. Turn OFF the gas at the cylinder after testing.
If detected leakage can not be rectified, do not attempt to fix the leakage but consult your gas dealer.

Regulator and hose

Use only regulators and hose approved for LPG at the above pressures (See Page 2). The life expectancy of the regulator is estimated as 10 years. It is recommended that the regulator is changed within 10 years of the date of manufacture.
The use of the wrong regulator or hose is unsafe; always check that you have the correct items before operating the barbecue.
The hose used must conform to the relevant standard for the country of use. The length of the hose must be 1.5 meters (maximum). Worn or damaged hose must be replaced. Ensure that the hose is not obstructed, kinked, or in contact with any part of the barbecue other than at its connection. Change the hose when the national conditions require it and/or depending on its validity.
The hose should not be twisted or kinked when attached to the regulator and outdoor gas grill. No part of the hose should touch any part of the appliance. Therefore, place the cylinder out to the left hand side of the appliance at the maximum distance permitted by the hose length.

CLEANING AND CARE

Warning
Danger of burns

Always test gas line for leaks at all connections with soap water.

We would recommend that this gas grill be serviced by your local gas retail outlet at least once a year by a competent engineer. Do not attempt to service this appliance yourself.

Cleaning

“Burning off ” the barbecue after every use (for approx. 15 minutes) will keep excessive food residue to a minimum.

Outside surface

Use mild detergent or baking soda and hot water solution. Non-abrasive scouring powder can be used on stubborn stains, then rinse with water. If the inside surface of the barbecue lid has the appearance of pealing paint, baked on grease build up has turned to carbon and is flaking off. Clean thoroughly with strong hot soapy water solution. Rinse with water and allow to completely dry. NEVER USE OVEN CLEANER.

Interior of barbecue bottom

Remove residue using brush, scraper and/or cleaning pad then wash with a soapy water solution. Rinse with water and allow to dry.

Plastic surfaces

Wash with a soft cloth and hot soapy water solution. Rinse with water. Do not use abrasive cleaners, degreasers or a concentrated barbecue cleaner on plastic parts.

Cooking plate

Use a mild soapy water solution. Non-abrasive scouring powder can be used on stubborn stains then rinse with water.

Grease tray

Please do not open the grease tray during use.
Before cleaning the grease tray, pull it out.
Please check the grease cup often and remove away the oil when 1/3 full.
After cooling down, pull the handle to remove the grease tray.

Cleaning the burner assembly

Turn the gas OFF at the control knob and disconnect the cylinder. Remove cooling grate.
Clean the burner with a soft brush or blow clean with compressed air and wipe with a cloth.
Clean any clogged ports with a pipe cleaner or stiff wire (such as an opened paper clip).
Inspect burner for any damage (cracks or holes). If damage is found, replace with a new burner. Reinstall the burner, check to ensure that the Gas valve orifices are correctly positioned and secured inside the burner inlet (venturi).
In some cases, the ignition of your barbecue will go out because of an insect crawling inside the burner venturi or a spider spinning its web inside the burner. This can be rectified by using a bottle brush inserted through the burner venturi and pushing it into the burner over the burner length. If condition persists consult your gas dealer.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of our fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

MANUFACTURER & IMPORTER (UK)

Manufacturer:

Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.

Importer for Great Britain:

Chal-Tec UK limited
Unit 6 Riverside Business Centre
Brighton Road
Shoreham-by-Sea
BN43 6RE
United Kingdom

Chal-Tec GmbH Wallstr. 16 10179 Berlin

WWW.KLARSTEIN.CO.UK

| Product name: Gas Plancha

Model number: 10033614

PIN code: 0063CN7292

---|---
Country of Destination| Appliance Category

Gas