KLARSTEIN 10033495 EL PASO Ceiling Fan Instruction Manual

: June 5, 2024
: Klarstein

Table of Contents

KLARSTEIN 10033495 EL PASO Ceiling Fan
SAFETY INSTRUCTIONS
INSTALLATION
OPERATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KLARSTEIN 10033495 EL PASO Ceiling Fan

SAFETY INSTRUCTIONS

Never attach the fan to a power point,but to the ceiling itself.
The minimum distance between the blades of the fan and the floor must be more than 2.3 m.The minimum carrying capacity of the hook from which the fan is hung must be 100 kg.
Make sure to install all poles disconnection switch having a contact separation of at least 3 mm between poles in the supply wiring to the ceiling fan.
The model or type reference of luminaries which may be installed in fans which are constructed for his purpose.
Switch off the power before connecting.
The electrical wiring must be in accordance with the local regulation.
The fan must be properly earthed to avoid the risk of electric shocks.
Never mount the fan in a moist or wet room.
Be careful when working near the rotating blades.

Note : Always have your fan installed by someone who is knowledgeable about electrical wiring.

INSTALLATION

Secure the mounting plate to a ceiling joist with two screws, spring washers and flat washers provided. Ensure the support for the mounting plate must be capable of safely and securely holding the moving weight of the fan.
Hang the fan assembly onto the mounting plate. The mounting plate has a lug on it; this should be lined up with the corresponding groove on the fan assembly ball joint.
Insert the remote control receiver between the bracket and the ball joint, and the sensor as shown.
Insert the male connector into the female connector (from the remote control receiver to the fan, and from the remote control to the terminal block.
Connect the wires from the earthed mains supply to the terminal block.
Lift up the canopy into place over the mounting plate. Ensure that you do not trap any wires.
Fasten the blade assembly to the motor with the screws and spring washers already attached to the motor.
Connect the light kit by clipping together the two plastic male/female connectors.
Fit the light kit to the switch housing by using the three light kit-fixing screws and star washers. Ensure that you do not trap any wires.
Install the light bulb.
Install the lampshade onto the lamp gallery by rotating the lampshade clockwise.

OPERATION

Manual

Select the fan speed by pressing the speed control button on the remote control transmitter:
- HI: High Speed
- MED : Medium Speed
- LOW: Low Speed
- OFF: Off
The switch on motor housing for controlling the fan blades rotating direction controls the direction of air movement. Before using this rotating direction switch, turn OFF the fan and ensure the fan stops rotating to prevent injury to yourself and damage to the motor.
Cold weather: Push the switch “UP” so that the blades will bring the warm air trapped near the ceiling fan to move downwards throughout the room.
Hot weather: Push switch “DOWN” so that the blades will create a breeze and circulate the air to the room.

Remote Control

Pressing the “ON/OFF” light button on the remote control transmitter can control the turning on or off of the light.
Pressing and holding the “DIMMER” button on the remote controller transmitter can adjust the level of light brightness.
Use the remote control transmitter to change the speed of the fan and to switch the light and fan on or off.
Replace the batteries by sliding the battery compartment cover on the remote control transmitter in the direction of the arrow, fit 2 x “AAA” batteries, ensure the polarity of the batteries match with the figures shown in the battery compartment
Note: The batteries for the remote control are NOT included.
Always ensure the battery compartment cover is closed properly.
Do not expose the remote control to direct sunlight.
Do not attempt to recharge expired batteries. There are special rechargeable batteries, which are clearly marked with.
Do not dispose of batteries in fire to avoid explosion.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service. This product contains batteries. If there is a legal regulation for the disposal of batteries in your country, the batteries must not be disposed of with household waste. Find out about local regulations for disposing of batteries. By disposing of them in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences.

TECHNICAL DATA