KLARSTEIN 10034668 Tower Fan Instruction Manual

KLARSTEIN 10034668 Tower Fan

Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care of the following hints to avoid damages. Any failure caused by ignor-ing the items and cautions mentioned in the instruction manual are not covered by our warranty and any liability. Scan the QR code to get access to the latest user manual and other information about the product.

TECHNICAL DATA

SAFETY INSTRUCTIONS

•  Remove the packaging and make sure that the appliance is intact. If in doubt, do
•  Remove the packaging and make sure that no parts have been damaged during transport. If any parts have been damaged, contact Customer Service immediately.
•  Children may be injured by the packaging materials and old equipment. Dispose of the packaging material immediately.
•  Children over the age of 8 and persons with reduced physical, sensory or mental capabilities or those with a lack of experience and knowledge may only use the device if they are instructed on how to do so by a person responsible for their safety who understands the associated risks.
•  Check the voltage on the device label before use. Connect the device only to mains sockets that correspond to the voltage of the device.
•  Only use the device for the intended purpose as described in the operating instructions.
•  Follow the instructions carefully during assembly. An incorrect assembly procedure can lead to irreparable damage to the device.
•  Turn off the power and disconnect the power cord before cleaning or when the device is not in use.
•  If the unit does not operate properly, turn it off immediately and contact a specialist workshop in your area.
•  If the power cord or plug is damaged, it must be replaced by the manufacturer, an authorised specialist or a similarly qualified person.
•  Do not connect the device to multiple sockets.
•  Do not use an extension cable.
•  Do not connect the device to timers or remote controlled sockets.
•  Do not operate or store the unit near heat sources such as heaters.
•  Never immerse the device or the plug in water or other liquids. If water leaks, disconnect the plug immediately and have the device checked by a specialist workshop.
•  When using the device for the first time, remove all film and all packaging material.
•  Do not pull the plug out of the mains socket by the cable, but rather hold it by hand when removing it.
•  Before plugging the plug into the mains, make sure that the device is switched off.
•  Do not stretch the power cord.
•  Make sure that all air inlets and outlets are clear and not covered so that the unit does not overheat.
•  Make sure that the power cord is not running over sharp edges or surfaces. Do not hang the unit on the ceiling or wall unless it is designed for this operation
•  Allow enough space around the device for walls, furniture, or other equipment to ensure the best possible performance.
•  Do not use the device near gas ovens or gas heaters.
•  Do not place the device near or directly under curtains.
•  Do not cover the device.
•  Do avoid catching a cold, do not expose yourself or others to direct airflow.
•  When you stop using the device, store it in its original packaging in a dry place.
•  Always unplug the appliance before cleaning, servicing, stowing or when you stop using it.
•  Do not use the device near explosive or flammable substances or liquids.
•  The appliance is not intended for commercial use but only for household and similar use. This includes use in kitchens in offices, farms, hotels, motels and facilities that offer bed and breakfast.

DEVICE OVERVIEW

1.  Handle
2.  Top cover
3.  Upper front housing
4.  Former decorative panel
5. Lower front housing
6.  Oscillation sockets
7.  Front base
8.  Upper rear housing
9. Rear decorative panel
10.  Rear lower case
11.  Rear pedestal
12.  Upper filter cover
13. Lower filter cover

DEVICE SETUP

1.  Remove the fan from the packaging and make sure the accessories are complete.
2.  Assemble the fan as follows:
   • Assemble the rear and front sockets (see Fig. 1).
   •  Insert the device body onto the base (see Fig. 2).
   •  After assembly, place the device in a suitable location.

COMMISSIONING AND OPERATION

Control panel

Remote control

Display panel

If you hear a beep the fi rst time the power plug is plugged into the mains outlet, it means that the fan has been properly connected. When the device is in standby mode, only the On / Off button can be pressed.

|

On/Off

| In standby mode, only this button is available. After pressing this button the fan will be switched on. The fan will run initially at low speed and in normal mode. Timer and vibration functions will be deactivated. The corresponding LED indica- tors will light up. The operating status, which was active at power off except for the timer and mode function, will be automatically restored at power up. If you press the On / Off button in the operat- ing status, the device will enter standby mode.
|

Level

| Press this button to select the desired fan speed, in order of low to high (levels). The correspond- ing number will appear on the display up.

|

Timer

| When you turn the unit on, the timer function will be disabled. Press the TIMER button to set the time until the unit automatically turns off. You can

choose between 1H-2H-4H-8H-no timer-1H, etc. The corresponding LED indicator will light up. If the timer has been activated, the device will run until the countdown expires and then turn off automatically.

|

Mode

| The initially set mode is ‘Normal’. Press the Mode button repeatedly to set a different wind mode. You may select between ‘Normal’ – ‘Sleep-

ing’ – ‘Natural’ – ‘Eco’ – ‘Normal’ by repeat- edly pressing this button. The corresponding LED indicator will light up (except in Normal mode).

Modes of operation (modes)

1.  Normal
   •  High speed (HI)
   •  Medium speed (MED)
   •  Low speed (LOW)
2.  Sleeping
   •  HI: 30 minutes “HI” natural wind—30 minutes ”MED” natural wind
   •  MED: 30 minutes “MED” natural wind—Remain “LOW” natural wind speed
   •  LOW: Remain “LOW” natural wind speed
3.  Natural

Oscillogram for 3 natural wind(HI, MED, LOW )

Eco-Modus
In this mode, the unit will run at temperatures below 25 ° C at low speed, at temperatures between 25 ° C and 29 ° C at medium speed and at temperatures above 29 ° C at high speed Automatic dimming function: If no button has been pressed for more than 1 minute, the backlight will automatically be dimmed by 30%.

MAINTENANCE AND CLEANING

Replacing the batteries of the remote control

1.  Open the battery compartment on the back of the remote control and insert a 3V CR2032 battery.
2.  Point the remote control at the receiver of the device.
3.  Remove the batteries from the remote control when not in use. Observe the correct polarity when inserting the batteries. Once you close the battery compartment after inserting the battery, the remote control will be ready for use.

Cleaning
If too much dust accumulates on the front ventilation cover and on the fan wheel, the functionality of the air outlet will be impaired. It is recommended to clean the fan at least once a month.

1.  Turn off the power and unplug the power cord from the wall outlet before cleaning, as this could result in electric shock or damage to the unit.
2.  Clean the device with a standard detergent and a brush. Do not use chemical substances.

Surface cleaning

1.  Make sure that no water or steam get on the unit.
2.  Do not use abrasive cleaning agents or solvents.
3.  Always unplug the power cord from the wall outlet before cleaning.

Storage

1.  Disconnect the power plug from the wall outlet and store in a cardboard box to prevent dust from entering the inside of the unit.
2.  After packing, store the device in a dry, well-ventilated place.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service. This product contains batteries. If there is a legal regulation for the disposal of batteries in your country, the batteries must not be disposed of with household waste. Find out about local regulations for disposing of batteries. By disposing of them in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences.

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>