LEDVANCE SMART Wifi Outdoor wall Camera Control DG User Guide
- June 5, 2024
- LEDVANCE
Table of Contents
**LEDVANCE SMART Wifi Outdoor wall Camera Control DG User Guide
**
ASSEMBLY INSTRUCTIONS
APP INSTALLATION AND USING INSTRUCTIONS
https://www.ledvance.com/consumer/smart/faq/
POWER ON/OFF AND CONNECTING INSTRUCTIONS
HOW TO USE
LIGHT SETTINGS
Time settings
- The time (switch-off delay) can be set from 5s — 360s
- Every detected movement re-activates the light
Twilight settings
The brightness response thresh-old (twilight) can be infinitely varied from
approx. 10-500Iux
Factory settings
- Time setting: 25s
- Twilight setting: 100Iux
AIMING FLOODLIGHT HEAD
The Floodlight head can be adjusted
- Up/down 50°
- Left/right 110°
CAMERA FUNCTION
- The camera films a sequence when the sensor is triggered
- The filmed sequence is saved on the memory card or cloud storage and can be retrieved at any time
- The recorded data is saved on the unit’s memory card or cloud storage
- A QR code is generated on the smartphone or tablet which can be read by another smartphone or tablet
- Once the sensor has been triggered, the user receives a push notification via the LEDVANCE App (can be deactivated)
- Open LEDVANCE App
- Use image display and intercom system
- Switch between HD and SD mode possible
- If HD image shows delay, SD is recommended
AIMING CAMERA
The camera can be adjusted (LEDVANCE WIFI APP)
- Up/down 90°
- Left/right 340°
ALARM FUNCTION
Acoustic alarm signal reacting on detected movement
FOUR SECURITY MODES
Sensor sensitivity can be adjust-ed (low, medium, high)
Low level:
- System default lighting environment: 100Iux
- Sensor distance: 5m
- Lumen adjustable: 10%-100%
- Lighting time: 25s
Middle level:
- System default lighting environment: 100Iux
- Sensor distance: 8m
- Lumen adjustable: 10%-100%
- Lighting time: 25s
High level:
- System default lighting environment: 100Iux
- Sensor distance: 12m
- Lumen adjustable: 10%-100%
- Lighting time: 25s
Further information on the functions and setting options can be found in the LEDVANCE App.
INSERT SD MEMORY CARD
- Remove cover
- Insert SD memory card
- Fit cover
RESTORING FACTORY SETTINGS
- Remove cover
- Using the needle, press reset button for approx. 3s until the signal sounds
While resetting:
Status LED lights up > Flashes fast
After resetting:
Acoustic signal one time Status LED flashes > Flashes slowly
- Open LEDVANCE App
- Clear camera in LEDVANCE App
- Re-configure unit
- Fit cover
LEDVANCE GmbH
Steinerne Furt 62 86167 Augsburg, Germany
www.ledvance.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>