Kid Galaxy 60194 KG BL Playzone Stunt Tumbler RC with Lights Instruction Manual
- June 5, 2024
- Kid Galaxy
Table of Contents
Instruction Manual
The Car requires one 3.7V rechargeable battery (included ). Not Replaceable.
The controller requires two AA 1.5V batteries(not included).
When changing batteries, adult supervision is required.
Use alkaline batteries for best performance.
LED Indicator. When fully charged, the red LED will be off.
Once the car is fully charged, switch the ON/OFF switch to the ON position at the bottom of the car. Use a screwdriver to remove the set-screw of the battery compartment door on the back of the remote controller. Install 2 AA 1.5V batteries.
Pairing
The car and the remote controller must be paired before the operation
- Turn the ON/OFF switch to the ON position, and the car will light up.
- Press the button on the remote controller (after batteries are installed).
- If you have more than one set of cars and controllers, pair them one at a time.
- Playing two cars at the same time is not recommended. They may cause interference with each other.
SAFETY PRECAUTIONS
Do not operate during thunderstorms or rain.
Avoid Water, sand, and snow when operating the car.
Do not submerge the car or controller in water.
Never operate your car in a conned or crowded area and do not use people or
animals as obstacles.
Do not run the car into furniture, objects or hard surfaces, as this will
cause damage to both the objects and your car.
Keep fingers, hair, and loose clothing away from the tires, gears, and motor
while the car is switched on.
Do not leave the car or remote controller near the source of heat or under
direct sunlight for long periods of time.
Do not leave the car or remote controller outside overnight, dampness is
harmful to interior components.
Remove all batteries when not in use to avoid accidental operation.
Adult supervision is recommended when operating this car.
BATTERY INSTRUCTIONS
- Please ensure all batteries are inserted in the correct direction(see diagram).
- Ensure all batteries are the correct type and size(see diagram).
- Do not mix old and new batteries. Replace all batteries at the same time.
- Batteries should be installed, changed, and removed by an adult.
- Do not mix battery types. Only use alkaline batteries in this product.
- Do not attempt to recharge non-rechargeable batteries.
- Promptly remove depleted batteries from the product.
- Remove batteries from the product before extended storage or product disposal.
- Do not dispose of batteries in the fire; batteries may explode or leak.
- To prevent short-circuiting of battery terminals, keep the battery compartment free of materials except for batteries.
- Do not throw batteries in household trash; dispose of them at battery collection stations.
FCC NOTICE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference,and (2)This device must
accept any interference received, including interference that may cause
undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>