KID GALAXY S615-2G4T Mega Morphibian Amphibious RC Car Mega Morphibians Crocodile User Manual
- June 5, 2024
- Kid Galaxy
Table of Contents
KID GALAXY S615-2G4T Mega Morphibian Amphibious RC Car Mega Morphibians
Crocodile User Manual
REMOTE CONTROLLER
- Unscrew the battery cover on underside of controller with phillips screwdriver.
- Insert 2-AAA batteries with polarities shown in battery compartment.
- Replace the battery cover and screw shut.
VEHICLE
- Unscrew the roof with phillips screwdriver to expose the batterfy box.
- Unscrew the battery door and insert 3-AA batteries with polarities shown inside battery compartment.
- Replace roof and screw shut.
How to play!
To get the vehicle start working, turn both power switch to “ON” position at the same time.
Trouble Shooting Tips
- When the LED light on the controller keeps blinking, the vehide & controller are NOT paired yet. Turn controller & vehicle power switch to “OFF” position. Wait 10 seconds for reset. Turn both power switch to “ON” position again to play.
- If the LED light on the controller is solid, on blinking, the vehicle & controller are paired and ready to play.
Call Kid Galaxy at 1-800-816-1135 for help if needed.
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radioflV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference, including interference that may cause undesired operation.
This device complies with Industry Canada’s license-exempt FtS5s. Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
The toy is to be operated in water only when fully assembled in accordance with the instructions.
The packaging must be retained since it contains important information.
Caution:
Please read these carefully before using:
- Only adults should install and replace batteries.
- Rechargeable batteries are only to be charged under adult supervision
- Rechargeable batteries are to be removed from the toy before being charged.
- Non-rechargeable batteries are not to be recharged.
- If the device has not used for a long time, remove the batteries.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon zinc) or rechargeable (nickel cadmium) batteries.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with the correct polarity.
- Do not dispose of batteries in fire, batteries may explode or leak.
- Batteries may explode or leak if misused.
©2020 Kid Galaxy, Inc.
All Rights Reserved.
Kid Galaxy, Inc. 150 Dow St. Manchester, NH 03101 USA
MADE IN CHINA
1-800-816-1135
Visit our website! | www.kidgalaxy.com
Conforms to the safety requirements of ASTM F963 and FCC regulations.
Conforms to toys regulations of Canada Consumer Product Safety Act.
Product and colors may vary from items shown.
Contains controller and vehicle.
BATTERIES:
- Vehicle requires 3 AA alkaline batteries (not included)
- Controller requires 2 AAA alkaline battery (not included)
Specification
Size of window box: 330.2L x 190.5D x 190.5H (mm)
Size of window box: 13″L x 7.5″D x 7.5″H (inch)
Flat size of box: 750(L) x 781 (H)mm
Flat size of insert: 645(L) x 360 (H)mm
Visible area of window: 252(L) x 286(H)mm
Material: 250gsm CCNB + [-Flute paper(box & insert) with diecut
Colour: CMYK
Finishing: UV
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>