MINN KOTA 2377123 Riptide Foot Pedal Accessory Owner’s Manual
- June 5, 2024
- MINN KOTA
Table of Contents
MINN KOTA 2377123 Riptide Foot Pedal Accessory Owner’s Manual
INSTALLATION OF THE RIPTIDE ST FOOT PEDAL
- Remove protective covers from both connector ends.
- Align connector keys and plug foot pedal into Riptide st motor. Be sure to tighten the connector retaining nut.
NOTICE: DO NOT APPLY LUBRICANT OR ANY TYPE OF GREASE TO TROLLING MOTOR CONNECTORS
LOW PROFILE FOOT PEDAL
FOOT PEDAL CONTROLS
All the controls in the foot pedal are easy to operate by either foot or hand. A light touch is all that is necessary.
-
Momentary. A toe touch on either of the two momentary buttons turns the propeller on. Let up and the propeller stops.
-
Mom/Con Switch. A toe touch to the Mom/Con button toggles the motor between momentary and constant.
When the motor is in constant the propeller will run continuously with out keeping your foot on the pedal. When the motor is in momentary, a toe touch is required to one of the momentary buttons to turn the propeller on. The Constant On indicator light will be lit when the motor is in constant state. -
Right/Left. Place your foot in the center of the heel/toe pedal, rocking forward steers right. Rocking back steers left. Left and right steering control can also be done with the Left/Right taps buttons. Holding the left or right steering button down steers left or right. Small steering changes of less than one degree can be made by quickly and lightly tapping the left and right steering controls.
NOTE: The steering system is designed to turn your motor 360°. Be careful to avoid over-wrapping the coil cord around the composite shaft. -
Forward/Reverse. The motors always drives forward by depressing the foot pedal. You can reverse the direction of thrust by turning the motor 180 0.
-
Speed Control. The speed selector is the calibrated rotating knob on the right side of the foot pedal. The speed knob provides infinitely variable speed control with the built in pulse modulation system. Use your hand or foot to rotate the knob to adjust speed.
-
AutoPilot (AutoPilot Models Only). A toe touch to the AP button toggles the AutoPilot On and Off. The AutoPilot On indicator light will be lit on the foot pedal and the center console of the motor when AutoPilot is on.
-
Non-Carpeted Boat Use. Enclosed with your motor are four (4) rubber bumpers. If the foot pedal is to be used primarily on non-carpeted surfaces, insert the rubber bumpers into the keyhole slots on the underside of the pedal. Slide the bumpers into the slot until they are locked into position.
-
Control Cord. The foot pedal cord is flexible and long enough to allow the pedal to be positioned almost anywhere on your boat.
ENVIRONMENTAL COMPLIANCE STATEMENT
It is the intention of Johnson Outdoors Inc. to be a responsible corporate citizen, operating in compliance with known and applicable environmental regulations, and a good neighbor in the communities where we make or sell our products.
WEEE Directive:
EU Directive 2002/96/EC “Waste of Electrical and Electronic Equipment Directive (WEEE)” impacts most distributors, sellers, and manufacturers of consumer electronics in the European Union. The WEEE Directive requires the producer of consumer electronics to take responsibility for the management of waste from their products to achieve environmentally responsible disposal during the product life cycle.
WEEE compliance may not be required in your location for electrical & electronic equipment (EEE), nor may it be required for EEE designed and intended as fixed or temporary installation in transportation vehicles such as automobiles, aircraft, and boats. In some European Union member states, these vehicles are considered outside of the scope of the Directive, and EEE for those applications can be considered excluded from the WEEE Directive requirement.
This symbol (WEEE wheelie bin) on product indicates the product must not be disposed of with other household refuse. It must be disposed of and collected for recycling and recovery of waste EEE. Johnson Outdoors Inc. will mark all EEE products in accordance with the WEEE Directive. It is our goal to comply in the collection, treatment, recovery, and environmentally sound disposal of those products; however, these requirement do vary within European Union member states. For more information about where you should dispose of your waste equipment for recycling and recovery and/or your European Union member state requirements, please contact your dealer or distributor from which your product was purchased.
Johnson Outdoors Inc.
Visit our website at http://www.minnkotamotors.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>