OTTO OTMICUSBDC USB Podcast Microphone Instruction Manual
- June 5, 2024
- OTTO
Table of Contents
OTTO OTMICUSBDC USB Podcast Microphone
PRODUCT OVERVIEW
INSTALLATION
-
Install the microphone clamp onto the tripod by turning it clockwise until it is secured
-
Insert the microphone to the microphone clamp by turning it clockwise until it is secured.
-
Turn the fastener screw anti clockwise to loosen it. Adjust the microphone clamp to a desired angle, then tighten the screw by turning it clockwise
-
Connect USB-B to the port at the bottom of the microphone. Connect USB-A to the USB port on your computer.
5.Orient the front of the microphone towards the sound source as the microphone captures the sound directionally
To enhance the quality of sound capturing, remove any noise source near the sound inlet area of the microphone.
- If echoing/feedback occurs in the presence of an audio speaker, please turn down the volume of the speaker or move the speaker away from the microphone.
INPUT LEVEL
Adjusting the input level on the microphone
Adjusting the input level on a Windows computer
- Open Sound Settings in
- Select “USB PnP Sound Device” as the device for sound
- Open the device properties and adjust the input volume to a desired level.
Adjust the input level on a Mac OS computer
- Open System Preferences on Mac
- Click on “Sound” to open the sound
- Open the “Input tab”.
- Select “USB PnP Sound Device” as the device for sound
- Adjust the input volume to a desired
SPECIFICATIONS
- Product Name: USB PnP Sound Device
- Officeworks Product Code: OTMICUSBDC
- Directivity: Cardioid
- Frequency response: 20Hz-20KHz
- USB interface: USB 2.0
- Input power: 5V=1A Max.
- Compatible systems: Windows®7 or later, Mac OS X 10.12 or later
PACKAGING CONTENTS
- Microphone x 1
- Microphone clamp x 1
- Tripod x 1
- USB cable (145cm) x 1
- Instruction manual x 1
- Quick start guide x 1
Warning
Do not connect this cable to products other than OTMICUSBDC USB Podcast
Microphone. Connecting this cable to other devices might cause damage to both
cable and the device.
Mac is trademark of Apple Inc., registered in the U.S. and other countries.
Windows is trademark of Microsoft Corporation in the U.S. and other countries.
PRODUCT WARRANTY
VALID FOR AUSTRALIAN CUSTOMERS ONLY
Officeworks Ltd warrants that this product will be free from defects and work
as intended for 3 years from the date of purchase by the original customer.
If the product has any defects or does not work as specified during the
Warranty Period, Officeworks will, at its election and at its expense, repair
or replace the product.
This warranty does not apply:
- to cosmetic damage;
- to damage caused by consumables used in connection with the product;
- where the product has not been used in accordance with all provided instructions;
- to damage arising from fair wear and tear;
- where the product has not been subject to reasonable use;
- where the product has been intentionally or negligently damaged; and/or if the customer has attempted to repair the product.
To make a claim under this warranty, please return your product with your
receipt or proof of purchase to your nearest Officeworks store or contact 1300
633 423.
This warranty is provided in addition to any rights you may be entitled to
under the Competition & Consumer Act 2010. Our goods come with guarantees that
cannot be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>