ELVITA CSD2350V Smart Dust Sensor Cordless Vacuum Cleaner User Manual

ELVITA CSD2350V Smart Dust Sensor Cordless Vacuum Cleaner

IMPORTANT SAFETY TIPS

When using electrical appliances, follow some basic safety tips, including the following: Please read all instructions before using the vacuum cleaner. Warning! In order to reduce the risk of fire, electrical shock or injury:

• Please store the vacuum cleaner indoors. Avoid using outdoors when it is raining. Do not immerse the appliance in water. Do not pick up the vacuum cleaner if you have wet hands.

• If the vacuum cleaner has been dropped, damaged, left outdoors or immersed in water, do not use it, take it to an authorized service centre for repair.

• Do not use charger power cord or plug if they are damaged.

• Do not unplug from the charger by pulling the power cord.

• Do not damage the charger power cord. Do not pull the power cord or lift the vacuum cleaner by the power cord, or use the power cord as a handle, or pull the power cord over a sharp edge or corner. Do not place the machine or power cord close to a hot surface.

• Do not use an extension power cord. The charger should be plugged directly into the power outlet.

• Do not put anything into the air intake of the appliance.

• Blocking the intake will limit the flow of air.

• Do not use the vacuum cleaner if any intake is blocked.

• Keep hair, loose clothing, fingers or any part of the body well clear of the appliance intakes and moving parts.

• Do not suck up hot, burning or smoking objects, such as cigarettes, matches or hot ashes.

• Do not suck up flammable substances (lighter fluid, petrol or paraffin, etc.) or use near explosive liquid or vapour.

• o not use this machine in enclosed spaces that are used to store paint, paint thinner, moth repellent, combustible dust, or other explosive or toxic vapours.

• Do not suck up toxic substances (e.g. chlorine bleach, ammonia, piped liquid or gasoline).

• Do not let children under the age of 8 use this appliance. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental abilities or lack of experience and knowledge
  if they are supervised or instructed in how to use the appliance safely and understand the hazards involved. Do not let children play with the appliance alone. Do not let children clean the appliance unless supervised by an adult.

• Do not use for any other purpose not listed in this User Manual.

• Please use only the accessories recommended by the manufacturer. Use of accessories provided or sold by another manufacturer may cause fire, electric shock or injury.

• The appliance must only be charged using the original power supply (charger). The battery must be removed from the appliance before it is scrapped. Disconnect from the charger before removing the battery. The battery must be handled safely.

• The charger must only be plugged into a standard power socket: 100–240 VAC 50/60 Hz).

• Keep the intake unobstructed to avoid the accumulation of dust, cotton wool, hair, etc.

• When unplugging the charger, grasp it by the plug, not the power cord.

• Clean stairs with extra care, to avoid tripping.

• Please turn off all control devices after cleaning.

• Do not charge outside.

• Turn off the power before cleaning or maintaining the appliance.

• Your Elvita hand-held vacuum cleaner contains rechargeable lithium batteries (Li).

• Do not burn batteries, as they will explode if exposed to high temperatures.

• In extreme cases, the battery may leak. If liquid from the battery comes in contact with the skin or eyes:

• Rinse immediately with warm water for at least 15 minutes.

• Seek medical attention immediately.

•  Please check the model type before replacing the battery pack.

• Non-rechargeable batteries cannot be used.

•  When using vacuum cleaners, please take care to install filter assemblies and floor brushes correctly.

• Please fully recharge the battery after using a new battery for the first time or before long-term storage. Make sure to charge and discharge the battery at least once every 3 months if the appliance is stored or unused for a long time.

• Do not use or store vacuum cleaners under adverse conditions, such as high temperature, low temperature, etc. Please store in a cool and dry place, do not allow long hours of sunlight exposure.

PRODUCT INTRODUCTION

BODY

ELECTRIC FLOOR BRUSH

DUST SENSOR

PRODUCT INTRODUCTION

• Package contents
• 115951 CSD2350V
• Cordless stick VC
• (white/golden)
• Digital MOTOR 350W
• Smart dust sensor
• FLuff Power Brush
• 3in 1 Crevice Tool
• 3in 1 Square Brush
• Extention Tube
• Wall Mount with charging
• 115952 CSD2350R Cordless stick VC (grey/red)
• Digital MOTOR 350W Smart dust sensor
• FLuff Power Brush
• 3in 1 Crevice Tool
• 3in 1 Square Brush Extention Tube
• Wall Mount with charging

Long aluminium tube
Due to continuous improvement of the product, the above configuration will vary depending on the model. We reserve this right. The right to explain is owned by the company.

INSTRUCTIONS FOR USE

Fitting the aluminium tube

• Push the end of the aluminium tube horizontally into the vacuum intake of the main body and ensure that it is securely attached. You should hear a click when it locks in place (Figure 1).
• To remove the aluminium tube, hold the main body with one hand and pull it out with the other hand while pressing the lock button (Figure 2).

Fitting the electric floor brush

• Insert the tube end of the electric floor brush into the open end of the aluminium tube and ensure that it is securely attached. You should hear a click when it locks in place (Figure 3).
• To remove the brush, grasp it in one hand, press the button with your other hand at the same time, and pull the brush out (Figure 4).
• Alternatively, the electric floor brush can be attached directly to the main body.

ACCESSORIES

Using accessories
In addition to the aluminium tube and electric floor brush mentioned above, you can also fit the special flat suction nozzle or square brush/electrostatic brush to suit a variety of cleaning applications (Figure 5).
Flat suction nozzle This is suitable for cleaning small rooms, crevices or irregular surfaces, such as wall corners, alloy window frames, home appliance interiors, drawers, car seats, picture frames, ceilings, keyboards, etc.
Square brush / electrostatic brush This is suitable for cleaning soft materials such as curtains, fabrics, sofas, etc. 3 in 1 Square Brush This is suitable for cleaning soft materials such as bedding, fabrics, sofas, etc. Extention Tube This is useful for cleaning hard-to-reach areas, thanks to the flexible hose.

Combination of flat suction nozzle and square brush / electrostatic brush These are useful for cleaning fabric surfaces and can be combined in two ways.
Mode 1: Push the round end of the flat suction nozzle into the intake on the main body. To remove it, pull it out directly (Figure 6).
Mode 2: Insert the upholstery or flat adapter into the crevice tool until it clicks
into place as shown in the diagram below. To remove the upholstery or flat adapter, press the release point (see diagram below).

• 3 in 1 Square Brush
• An accessory with many uses
• Figure 9 (Flat suction nozzle)
• Possible combination with
• extension tube
• Figure 10 (Square brush / electrostatic brush)
• Possible combination with
• extension tube

Charging:

• A steady red light indicates that the battery is charging.
• A steady blue light indicates that the battery is fully charged.

Extention Tube
An accessory that is useful for cleaning hard-to-reach areas, thanks to the flexible hose.

BATTERY INSTALLATION INSTRUCTIONS

Slide the battery on to the base of the main body in the direction shown in Figure 11, so that it is held securely You should hear a click when it is securely attached.

Note:
For long-term reliability, keep the battery in a cool, dry place, and leave the battery in a semi-charged state. Please wrap the battery with non- conductive material to avoid direct contact with the battery terminals, which could cause damage to the battery. A replacement battery can be purchased from all after-sales networks.
Technical data

The Company reserves the right to make any technical and design changes to the product as a result of continuous improvement. The explaining title belongs to our company.

PRODUCT USE

Preparation
Before using, please install the battery and check that the battery is charged. If not, connect it to the charger until it is fully charged. Accessories can be chosen to suit the type of area to be cleaned. The vacuum cleaner is supplied with a variety of accessories. You should choose the most suitable accessory for the area to be cleaned (see “Instructions for use” for details).

Starting work
Press the power button to start the appliance, and press it again to stop the appliance. Smart dust sensor During use you can press the auto button to automatically sense the dust level and automatically adjust suction, or you can adjust the suction manually using the + or – buttons.

Emptying dust
After stopping the machine, press the release button on the side of the dust barrel  Open the cover, tip out the dust, and close the dust barrel cover

Removing the filter
Press and hold down the buttons on the cover, open the cover, and remove the filter element

Charging the battery
Connect the end of the charger power cord to the body or charging dock and plug the charger into a power socket.

Charging indicator
Working status: indicator light is constantly on. Charge state: Still charging: indicator flashing Fully charged: indicator light constantly on
Note:
After the product leaves the factory (depending on usage), please use the supplied charger to recharge the battery for 3 hours every 3 months (it does not need to be fully charged). Do not leave the battery on charge for a long time. If the battery is over-charged it could lead to overheating, deformation or fire. If the battery is not used for a long time or if it is deeply discharged, it may not deliver full capacity for the first few cycles. In this case it is recommended that the battery is fully discharged after charging. It is only necessary to repeat this action twice.

DAILY MAINTENANCE

Product maintenance
To ensure reliable performance of this appliance, it is recommended that you maintain its components on a regular basis. Before cleaning the main body (hand-held part), make sure the appliance is switched off and not connected to the charger. Wipe with a cloth that is moistened with water or a neutral detergent. Make sure the cloth is only slightly damp. Do not allow water to get into the internal parts of the vacuum cleaner (Figure 20). After cleaning, do not place it in direct sunlight or in a wet place.
Cleaning the dust barrel
When the dust reaches the “MAX” level, empty the dust barrel as soon as possible and do not overfill it. To make it easier to remove the dust barrel, it is recommended that you remove the aluminium pipe or other accessories before cleaning. After the appliance has been switched off and come to a stop, open the dust barrel cover and tip out the dust. If any stubborn dirt is found inside the dust barrel, please wipe it carefully with a damp cloth. After cleaning, close the dust barrel cover and make sure the lock button is closed.
Note:
After wiping the inside of the dust barrel with a damp cloth, the dust barrel should be placed in the sun to dry completely before the dust barrel cover is closed.

Cleaning the air filter sponge
To ensure reliable performance of the appliance, it is recommended that you regularly clean the filter sponge, and replace it after 3–6 months. (depending on usage). Press and hold down the dust barrel release button, remove the body and open the cover, remove the sponge, and brush the dust off the sponge  If there is a lot of accumulated dust, wash the filter sponge thoroughly and dry it before refitting it in the main body.
Note!
During washing, use cold water and dry the sponge thoroughly (usually in sunlight for 24 hours), then put it back into the body.

Cleaning the standard roller
The standard roller should be cleaned every four to five uses. A groove is provided for this purpose. Use a blade or a pair of scissors to gradually cut away any hair or debris that is clogging up the roller, taking care not to damage the integrated bristles.

STORAGE

Charging dock storage: convenient, space-saving accessory storage (Figure 22): provides easy storage and removal. Place the wall mount against the wall in the desired location for installation. Make sure the wall mount is high enough so that the vacuum cleaner will hang without touching the floor.

• Using a pencil, mark the locations of each of the holes in the wall mount. Use a spirit level to ensure that the wall mount is mounted perfectly horizontal.
• Drill the holes using a suitably sized drill bit, and fit wall plugs that are appropriate for the wall construction. Hold the wall mount against the wall, insert the screws through the mount and tighten them .

TROUBLESHOOTING

Identifying and fixing common faults

Recharge the battery.
The vacuum intake is blocked.| Clean the vacuum intake.
Insufficient suction| The dust barrel and/or filter components are full of dust.| Clean out dust barrel and filter.
The roller brush is entan- gled with hair, etc.| Clean the roller brush.
Problem persists after car- rying out the above checks.| Please contact our

after-sales service for main- tenance.

The motor makes abnormal sound| The main intake or alumini- um tube are blocked.| Clear the obstruction from inside the main intake or aluminium tube.
Problem persists after car- rying out the above checks.| Please contact our

after-sales service for main- tenance.

The product cannot be recharged| The charger is not properly connected to the appliance.| Please check and ensure a good connection.
Problem persists after car- rying out the above checks.| Please contact our

after-sales service for main- tenance.

If you cannot fix a problem by following the troubleshooting steps above, please contact our after-sales service department for help.

References

• Köksvaror, vitvaror och elektronik för hela hemmet - Elvita

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>