HUBBARDTON FORGE 346013 Outdoor Fixtures Post Light Instruction Manual

HUBBARDTON FORGE 346013 Outdoor Fixtures Post Light

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

Component Parts

Note: Fixture, Post and Cover Cap each sold separately.

A J Bolts – Included with optional post/pier mount
B Fixture post – optional and sold separately
C Washers (4) – Included with optional post/pier mount
D Split washers (4) – Included with optional post/pier mount
E 5/16 nuts (4) – Included with optional post/pier mount
F Cover Cap – optional and sold separately
G Fixture
H Set screw
I Rubber Strip
J Fixture Collar

To Install (Figures 1 & 2)

Caution: Be sure power is off at the main breaker box prior to installation.

Site Preparation

1. Run appropriate wiring to the site of the fixture, leaving enough excess wire to reach the top of the post, plus 12 inches.
2. Pour flat and level concrete base with wiring emerging at the center. Insert J bolts (A) so approximately 1″ of the bolts are exposed above the concrete. Position J bolts according to the supplied template. Allow concrete to cure before installing fixture.

Installation

Note: Post may be cut to length as desired before installation begins.

1. Position post over J bolts allowing supply wire to run up though the post and secure using washers (C), split washers (D) and nuts (E).
2. Place optional cover cap (sold separately) (F) over post to conceal mounting hardware.
3. Connect fixture wires to supply wires using appropriate wire connectors (not provided), black to black, white to white and bare copper or green to bare copper or green. If fixture is wired with twin lead lamp cord, connect smooth side of fixture wire to black and ridged side to white.
4. Install the rubber strip (I) centered on each inside wall of the fixture collar.
5. Place fixture (G) onto post carefully tucking all wiring down into post and making sure no wires are pinched between the post and the fixture. Secure with set screw (H) using a 1/8” hex key wrench (not supplied).

Use this template to position J bolts and wireway in concrete slab prior to installing outdoor post mounted lighting fixture.

Component Parts

Note: Fixture, Post and Cover Cap each sold separately.

K Glass
L Retaining Ring (2)
M Glass Shield
N Threaded Socket

To Install (Figure 3)

Caution: Be sure power is off at the main breaker box prior to installation.

1. Position Glass Shield (M) over Threaded Socket (N) and secure with the two Retaining Rings (L).
2. Install 150-watt max type A light bulb and glass (K).
3. Note: The glass is mouth blown. Minor irregularities, including being slightly out of square, are normal. It may be necessary to turn the glass in relation to the fixture to achieve a good fit.
4. Restore electricity to breaker.
   

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product. We hope you enjoy your fixture!

• Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture

Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>