ELVITA E115688 Ceiling Spot Light User Manual
- June 5, 2024
- ELVITA
Table of Contents
ELVITA E115688 Ceiling Spot Light
INSTRUCTIONS
- For indoor use only.
- Do not install in bathrooms, wash rooms or other similar wet rooms.
- Warning! Always disconnect the power to the circuit before electrical installation, connection and service.
- The electrical installation must comply with current safety regulations to prevent life-threatening accidents. The installation of this product should only be performed by someone with a good knowledge of electrical wiring. Contact a qualified electrician if in any doubt.
- The product is intended to be connected to 230 V~, 50 Hz.
- GU10 Max. 35W bulb should be used in this luminaire.
- Allow the lamp to cool down before changing bulbs. Halogen bulbs can get very hot.
- For household use only. To be installed in a ceiling, out of reach.
- Use only with self-shield tungsten halogen lamp (or LED). • The minimum distance from lighted objects: 0.5m.
- Only use a dry cloth to wipe the light clean when needed. Never use liquids or abrasive detergents.
- The product must be installed above 2.5m height, and out of arm reach.
INSTALLATION
Install the light in the order 1-5 as below picture is showing. The wires
should be connected to the terminal block according to the diagram.
Note: The light needs to be earthed. If in any doubt about proper
installation, contact a qualified electrician.
DISPOSAL
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities. Contact your local government for information
regarding the collection systems available. If electrical appliances are
disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
Marknadsförs av ELON GROUP. +46 (0) 10-220 40 00.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>