Dryflow TFJ0 TurboForce Junior Plus Hand Dryer User Manual
- June 5, 2024
- Dryflow
Table of Contents
- Dryflow TFJ0 TurboForce Junior Plus Hand Dryer
- SPECIFICATIONS
- WARNING
- Feature
- Name of each part
- Electrical diagram
- Precautions before installation and Installation location
- Install method
- Test run
- Daily use and maintenance
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Dryflow TFJ0 TurboForce Junior Plus Hand Dryer
SPECIFICATIONS
WARNING
If you don’t use this unit properly or follow the safety guidelines carefully, it would lead to serious personal injury or potential damage.
-
Do not open the front panel. Otherwise, you may get an electric shock.
-
Do not let children hang from the unit. Otherwise, this may cause the unit to drop.
-
Do not allow the unit to get wet. Otherwise, it will cause electric shock
-
Do not use in a wet environment, for example, near the bathroom where it may get the direct water and the places where condensation may form. Otherwise, this may cause electric shock and unit malfunction.
-
Do not modify and disassemble the unit unnecessarily. Otherwise,this may cause a fire,electric shock, or personal injury.
-
Rated power is required
-
If power tolerance is over +/-10%,there will be breakdown If using incorrect power supply, fire, electric shock and machine malfunction will happen.
-
Please use dedicated socket
-
If using together with other appliances, the socket may cause abnormal heat leading to fire.
-
Power must be cut off during maintenance to prevent the risk or electric shock. Air filter must be installed.
-
If the machine doesn’f work or have abnormal conditions, please cut off power to prevent accidents; and close leakage circuit breaker and ask supplier to check and repai, or it may lead to fire because of electricity leakage and short circuit.
-
Attention when installing:
Do not install when the machine has power connected. -
This appliance is not intended for use by persons(includingchildren) with reduced physical, sensory or mental capabilities,or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
-
If the cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
-
For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
-
Environmental Protection Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.
Feature
- No touch hand drying ensures complete hygiene.
- No need for paper towels, ease of maintenance.
- Stainless steel cover, solid and beautiful appearance.
- Auto-stop function, the built-in timer will stop the unit after 45 seconds.
- The machine is equipped with automatic heating system, when temperature is cold, it automatically opens the heating system, when the temperature is hot, the heating system automatically shuts down.
Name of each part
Electrical diagram
Precautions before installation and Installation location
-
Do not install in the following places (otherwise may cause malfunction).
- Place with temperature below -10’C or over 40C
- Place directly sprinkled by water
- Place with direct sunlight, strong light
- Place easy for condensation
- Place filled with corrosive, oxidizing and reducing gas
- Place with altitude over the range of 0-2000m
-
Installation location
-
The following picture shows the recommended location. (If there is floor or obstacles below the hand dryer, the distance between machine
and floor or obstacles should be at least 400mm.) -
Keep the right side ofdryer away from mirror or wall for the water droplets may splash Out when you dry hands. ( the distance should be 100mm or above)
-
Please avoid the place easy to meet people and easy to encounter doors.
-
Please select flat wall to install this product.
-
Install method
Connect the power supply line
- When installing dryer without junction box, you should install above the right side of dryer two-hole standard outlet corresponds tohand dryer.The distance should be 20-50cm.
- Please embed junction box without cover in the installation location when directly connecting power cord is needed. Other wise power cord will be forced out of body and can not be properly installed.
Cover removal
- Using allen wrench from accessories bag to remove 2 countersunk screws from cover.
- Pull the cover upward by hands to remove.
- Keoping the cover carefully avoiding Scratching.
Machine installation
- As figure shows, the machine is to be fixed on the wall by screws. The machine has been equipped with a power cord. If needing junction box for installation, the power cord must be removed. As figure shows, the wire is drawn out through thread hole to the terminal blocks to connect.
- When connecting, the wire length should exceed 2cm to terminal block. Fire line must be connected at L position of terminal blocks, null line connected at N position, earth line connected at
Cover installation
Tighten the 2 countersunk screws on the cover.
Test run
| | |
---|---|---|---
| | | If not correctly installed the machine will shake and rattle.
|
| |
| | | Power socket must be matching the machine plug.
Please check the power when the indicator light is off.
| Place your hands in the drying area| High speed air blown out| Please confirm whether your hands are far away from the sensor parts if there is no air blowing out.
Daily use and maintenance
External maintenance
-
Clean with a soft dry cloth or towel. Please use neutral detergent Please don’t use organic solvents, acid or alkali toilet cleaner, cleaning brush etc
-
Otherwise, this will damage the machine surface finish or produce discoloration.
-
lf using a chemical cloth, make sure that the use of attention.
-
Place the back of the hands under the airflow. Move backwards and forwards.
-
Place the palms of the hands under the airflow. Move backwards and forwards.
-
Rub the hands together.
7 Riverside Court, Don Road Sheffield, $9 2TJ. UK.
Tel: +44 (0)114 3540047
Email: info@dryflow.co.uk
www.dryflow.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>