X-DRAGON XD-SC-013 Solar Charger User Manual

**X-DRAGON XD-SC-013 Solar Charger User Manual

**

Thank you for purchasing our product. For optimum performance and safety, please read these instructions carefully before operating the product. Please keep this manual for future reference.

Product Features

1. Short press main button to access power-consumption inquiry — 4 LED blue indicators for power balance(1-25%, 26-50%, 51-75%, 76-100%), indicators will automatically turn off after 10 seconds without charging. (The green pilot light up when charging by sunshine.)
2. 11Iumination mode: Long press main button and hold the pressing for 3 seconds to turn on/off the flash lights; Short press again turn to SOS mode ; Short press once again to switch to strobe mode.

Specifications

Solar power: Peak 1.5×4=6W
Battery: 25000mAh Li-polymer battery
Material: ABS
Input: Micro 5V2A(Max.)(Micro USB/USB-C, choose only one charging port each time.)
Output: 5V2.4A(Max. Single port) 5V2.8A (Max. Overall for two ports) Dimension:
Folded : 1558335mm/6.13.31.4inch
Unfolded : 380’153 23mm/15.06.0*0.90inch
Weight: 570.5g/20.12oz

How to use

1. Charge the solar charger with a wall charger(5V2A, full charging time 9.5 hours approximately) It is not recommend to charge via computer as the output power is much lower(USB 2.0–5V0.5A, USB3.0–5V0.9A).

   • Make proper connection between solar charger and your wall charger with an certificated USB cable or the provided one.
   • After connecting, blue LED indicators keep flashing which indicate that the solar charger is in charging status.
     When it is fully charged, 4 blue LED indicators stay on continuously.
     Note: When connecting, please do choose certificated adapter and USB cable as some none branded ones might bring up to 50% power loss. ‘

2. Charge the solar charger itself via solar energy.

   • When the automatic sensitive lamp lights in green, expose panel towards sunlight (vertical direction) to get the maximum solar energy.
   • The green light will be on which indicate the solar charger is in the charging status.
     Note: The solar panel is meant to be used in emergency and extend the battery life due to its small capacity, the current is relatively small in cloudy day or indoor, it is recommended to recharge it in full sun or connect it to a wall charger.

3. How to use solar charger to recharge mobile phones or other USB-powered devices.

   • Short press on the power button to show battery balance, there is no output when battery is in low capacity. Please recharge the solar charger first.
   • Make proper connection between solar charger and your devices with an certificated USB cable or the provided one.
   • Please check whether the phone or USB powered devices show a charging sign or not, otherwise press the power button again or try a different USB cable.

Wireless charging

Wireless charging input: 5V/1.5A output: 5V1.0A
Radio conversion rate: 66.6%
Charging frequency: 110-205 KHz
The effective distance of wireless transmission of electric energy:
5-8 mm (the thickness of the protective shell of the mobile phone should not exceed 5mm, the material of the mobile phone case should not contain interference substances such as metals or metal alloys. )
Compatibility: Support mainstream QI standard wireless charging models, not support wireless charging modelslt can be used with wireless charging receiver.

note:

1. Make sure you have placed your phone in the center of the wireless charging area before starting charging,
2. During the charging process, it may be normal for the surface area of the wireless charging to heat up.

Cautions

1. For first use, please recharge battery to full and do not recharge until it is discharged to 0%. But for daily use, it is recommended to always leave at least 10-25% capacity unused.
2. For connecting, please use your original adapter and cable or the cable provided by our company, as some non-branded data cables with high internal resistance will bring up to 50% power loss.
3. Unlike maintenance-free primary battery(such as AA,AAA batteries), it is suggested to fully recharge this power bank at least once every 90 days.
4. Please handle it with care, and avoid hitting it with sharp objects or knocking heavily on it.
5. In case any short-circuit, this product is not allowed to put in the rain, water or fire.
6. Dual outputs support two devices at the same time, but please confirm the input voltage and current requirements of your devices first(Please refer to your device’s manual or product labeling), otherwise, the control system will shut down to prevent the circuit board from getting overheat.
7. For safety sake, it is not suggested to place it on car dashboard for usage, as the temperature inside car might goes up to 60-75 C .
8. Clean dirt on the surface of solar panel as necessary, Always use water and a soft sponge or cloth for cleaning. A mild, non-abrasive cleaning agent with no corrosivity is strongly recommended.

FAQ and Solutions

1. What if the solar charger fails to charge itself ?
   A: Sometimes it will not charge if the sunlight is not strong, cause the generated power of the solar panel is small and it will loose some power during the conversion; besides, when mobile device is on standby, it also leads to power reducing. So please expose the panel under strong sunlight. Solar charger is just for emergency use.

2. Why can’t I charge other 5V external devices?
   A: Make sure the connection between the solar charger and your device is secure. B: Make sure the solar charger still has a charge. If it is completely discharged, recharge it and then retry charging your device. C: Ensure that the solar charger’s output current and voltage are compatible with your device.

3. Why can’t I charge my Bluetooth device with the solar charger?
   A: The solar charger will not charge devices with input currents lower than 50mA, including some Bluetooth and GPS devices.

Warranty

We have 18-month warranty for this product (from date of its original purchase). If you have any concerns regarding to our product or service, please email us at [email protected], we will response within 1 business day! Website: www.x-dragon.net

FCC Statement

This device complies with part 18 of the FCC Rules. Operation is Subject To the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not explicitly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

Note: this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
This device complies with Part 18 of the FCC Rules. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment doe  cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Increase the separation between the equipment and any other radio device.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>