Gerlach GL 1281 Electric Kettle User Manual
- June 5, 2024
- Gerlach
Table of Contents
Gerlach GL 1281 Electric Kettle
Overview
SAFETY CONDITIONS IMPORTANT INSTRUCTIONS ON SAFETY OF USE PLEASE READ
CAREFULLY AND KEEP FOR FUTURE REFERENCE
The warranty conditions are different, if the device is used for commercial
purpose.”
- Before using the product please read carefully and always comply with the following instructions. The manufacturer is not responsible for any damages due to any misuse.
- The product is only to be used indoors. Do not use the product for any purpose that is not compatible with its application.
- The applicable voltage is 220-240V, ~50/60Hz. For safety reasons it is not appropriate to connect multiple devices to one power outlet.
- Please be cautious when using around children. Do not let the children to play with the product. Do not let children or people who do not know the device to use it without supervision.
- WARNING: This device may be used by children over 8 years of age and persons with reduced physical, sensory or mental capabilities, or persons without experience orknowledge of the device, only under the supervision of a person responsible for their safety, or if they were instructed on the safe use of the device and are aware of the dangers associated with its operation. Children should not play with the device. Cleaning and maintenance of the device should not be carried out by children, unless they are over 8 years of age and these activities are carried out under supervision.
- After you are finished using the product always remember to gently remove the plug from the power outlet holding the outlet with your hand. Never pull the power cable!!!
- Never put the power cable, the plug or the whole device into the water. Never expose the product to the atmospheric conditions such as direct sun light or rain, etc.. Never use the product in humid conditions.
- Periodically check the power cable condition. If the power cable is damaged the product should be turned to a professional service location to be replaced in order to avoid hazardous situations.
- Never use the product with a damaged power cable or if it was dropped or damaged in any other way or if it does not work properly. Do not try to repair the defected product yourself because it can lead to electric shock. Always turn the damaged device to a professional service location in order to repair it. All the repairs can be done only by authorized service professionals. The repair that was done incorrectly can cause hazardous situations for the user.
- Never put the product on or close to the hot or warm surfaces or the kitchen appliances like the electric oven or gas burner.
- Never use the product close to combustibles.
- Do not let cord hang over edge of counter or touch hot surfaces.
- Never leave the product connected to the power source without supervision. Even when use is interrupted for a short time, turn it off from the network, unplug the power.
- In order to provide additional protection, it is recommended to install residue current device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact professional electrician in this matter.
- If the kettle is overfilled it may spurt boiling water.
- WARNING: Do not open the lid if the water is boiling.
- The kettle must only be used with the provided base.
- CAUTION: Before lifting the kettle from the base make sure that the kettle is turned off.
- This equipment is intended for domestic and similar use, such as: staff kitchens in stores, offices and other work environments, utility rooms, by customers in hotels, motels and other residential environments of this type, in bedrooms and dining rooms.
- Always use caution when boiling water in the kettle. Do not touch the housing of kettle or lid. Do not open the lid during boiling in kettle or immediately after boiling, because steam coming out of lid can cause burns.
- Move the kettle only by holding it by handle..
- Never fill kettle above MAX level and below MIN level. It may cause damage of kettle.
- Never switch on kettle without water.
- Never use kettle without filter or with open cover (automatic shutdown will not work).
- Descale your kettle regularly. Using kettle with heating element covered by scale may cause damage.
- Do not use aggressive detergents to wash the kettle housing – they can damage the kettle or remove the markings.
- The device is not designed to work with external schedulers or separate remote control system.
- Do not wash the base of the kettle directly in the water, just wipe with a dry cloth.
- Children aged 3 to 8 years old can enable and disable the device only when it is in its normal position of use, they are supervised or instructed on the safe use and understand the resulting risks. Children aged 3 to 8 years old can not connect device, operate, clean or maintain.
DESCRIPTION OF THE DEVICE. ELECTRIC KETTLE AD1295
- Lid
- Handle
- Power knob/temperature control
- LCD display
- Base
- Housing
- Mesh filter
- Keep warm function indicator
BEFORE FRIST USE
Fill the kettle three times with water to the maximum level, boil and pour it. To remove any factory odor.
BASIC OPERATION:
SINGLE WATER BOLING UP TO 100 ℃
- Fill the kettle with water so that the water level is between the maximum and minimum levels on the water level indicator under the handle (4).
- Place the base (5) on a stable, flat and heat-resistant surface.
- Remember to close the kettle with the lid (1) after filling, otherwise the kettle will not switch off automatically when the water boils.
- Insert the power plug into the 220-240V ~ 50 / 60Hz power socket. Place the kettle on the base (5), the knob (7) will light red, wait until you hear the “di-di” sound twice.
- Press the knob (7), the knob will turn green, the display (2) will blink twice, indicating 100 ℃, then the heater will start heating the water, and the LCD display (2) will show the current water temperature . The water temperature will rise until it boils, i.e. up to 100 ° C.
- After the water boils, the kettle will automatically turn off, the knob (5) will turn red, you will hear the “di-di” sound twice.
- To turn off the kettle before the water finish boiling, lift it off the base (5).
- You can start the kettle again after approximately 2 minutes from the last use.
- When the device is not in use, the display (2) and knob (7) turn off lighting after 5 minutes.
ADVANCED OPERATION:
SINGLE WATER BOILING TO THE SELECTED TEMPERATURE 40 ℃ OR 50 ℃ / 60 ℃ / 70 ℃ /
80 ℃ / 90 ℃ Put the kettle on the base (5), wait until you hear the “di-di”
sound twice. Briefly press the knob (7), the knob will turn green, you will
hear a single “di” sound, turn the knob clockwise (or vice versa), the display
(2) will show the temperature you choose 40 ℃ (or 50 ℃ / 60 ℃ / 70 ℃ / 80 ℃ /
90 ℃) and blinks three times remembering the setting of the selected
temperature level. Then the display will show the current water temperature
inside the kettle. The kettle will stop boiling water when it reaches the
selected temperature level of 40 ℃ (or 50 ℃ / 60 ℃ / 70 ℃ / 80 ℃ / 90 ℃), the
knob (7) will turn red, you will hear the “di- di “sound twice. KEEP WARM
FUNCTION AT THE SELECTED TEMPERATURE 40 ℃ OR 50 ℃ / 60 ℃ / 70 ℃ / 80 ℃ / 90 ℃
/ 100 ℃ Put the kettle on the base (5), wait until you hear the “di-di” sound
twice. Press the knob (7) FOR 2 SECONDS until the icon (8) appears on the
display (2), the knob turns green and flashes, turn the knob clockwise (or
counterclockwise), the display (2) will show the temperature you choose 40 ℃
(or 50 ℃ / 60 ℃ / 70 ℃ / 80 ℃ / 90 ℃) and blink three times remembering the
setting of the selected temperature level. Then the display will show the
current water temperature inside the kettle. The kettle will stop boiling
water when it reaches the selected temperature level of 40 ℃ (or 50 ℃ / 60 ℃ /
70 ℃ / 80 ℃ / 90 ℃), you will hear a single “di” sound, the knob will turn red
and will blink for 2 hours. Within 2 hours, the kettle will heat the water
cyclically, constantly displaying the selected temperature level to maintain.
When the water temperature drops by 5 ℃ in relation to the selected
temperature level of 40 ℃ (or 50 ℃ / 60 ℃ / 70 ℃ / 80 ℃ / 90 ℃), the device
will turn on automatically and heat it.
Note: Only during this procedure, the keep warm function will be active.
After removing the kettle from the base, the keep warm function settings will
be reset.
PROTECTION DEVICES
The device is equipped with an automatic fuse against overheating, the fuse will trip when the kettle was used with insufficient water. Always make sure that the volume of water in the appliance is above the minimum level. If the fuse turns on, turn off the kettle by pressing the knob (7), then remove the plug from the power socket and allow the kettle to cool for 5-10 minutes. Then fill the kettle with water and turn on the device that will operate normally.
CLEANING AND MAINTENANCE
Limescale deposits inside the kettle should be removed regularly. This operation is not covered by the warranty service. Lack of regular descaling leads to damage to the kettle and loss of warranty. For descaling, use preparations specially designed for this purpose in accordance with the instructions for the descaling agent. After descaling, rinse the kettle thoroughly three times. Remove the filter (6) as needed to rinse under running water. Device is made in class I of insulation and has to be connected only to power outlet with ground circuit. Device is compliant with EU directives:
TECHNICAL DATA
Max capacity: 1.7L min: 0.5L – Low voltage directive (LVD)
Voltage: 220-240V ~ 50 / 60Hz – Electromagnetic compatibility (EMC)
Power: 1850-2200W Device marked CE mark on rating label
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may effect the environment. Do not dispose this appliance in the common waste bin.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>