Eurotronic Technology sprit Z-Wave Smart Radiator Thermostat Installation Guide

Eurotronic Technology sprit Z-Wave Smart Radiator Thermostat

User manual and Guarantee

Please read this User Manual carefully before installing the Spirit Z-Wave Plus thermostat and store this manual for documentation.

NOTE: You find a detailed installation and operation guide online:
https://eurotronic.org/service/downloads/
Z-Wave gateway is required for commissioning.

Scope of delivery

1 Spirit Z-Wave Plus energy saving controller
1 Operating instructions (part of the product)
1 Screw for adapter
3 adapter (Danfoss RA, RAV, RAVL)
2 batteries LR6 AA 1,5 V

Safety Instructions

• Spirit Z-Wave Plus is designed for use in buildings.
• Operate Spirit Z-Wave Plus only as described in the user manual.
• Spirit Z-Wave Plus should only be put to use in a dry and dust-free place, away from direct sunlight
• Do not keep using the device when there is obvious damage.
• Spirit Z-Wave Plus may not be rebuilt, modified or opened.

Warning

Never recharge batteries, do not short circuit them, do not take them apart – Risk of explosion! Remove dead batteries from the device immediately.
Do not use old and new batteries together.
Clean battery and device contacts before inserting if necessary.
Keep batteries away from children. Avoid contact with skin, eyes and mucous membranes. In case of contact with battery acid, rinse the affected areas immediately with plenty of water, and seek medical attention immediately

Inserting / replacing batteries

Inserting / replacing batteries
Remove the battery cover by simply pulling it off. Now insert the batteries. Pay attention to the correct polarity! At a later battery change, the configuration of your Spirit Z-Wave Plus is maintained.

Controls-/ Display elements

Lights up if mechanical tasks are ongoing.
Displays if the Spirit Z-Wave Plus is included.
Lights up if the Display shows the Z-Wave NodeID.
Lights up if less than 15% battery is remaining.
Lights up if child protection is set.
C Displayed if the LCD shows a setpoint temperature.
% Displayed instead of °C Icon if the Spirit Z-Wave Plus is set to direct control mode

Including

Set your primary Z-Wave Gateway to inclusion mode and follow the steps.

1. Inclusion mode (Inclusion) is displayed
   ⇒ Press Boost-Button

2. Display shows Node-ID
   ⇒ Inclusion completed

3. Installation mode is displayed
   ⇒ Please mount the radiator.

Mounting

1. Turn the manual thermostat head up completely, loosen the fastening and pull the thermostat off of the valve.

2. Use an appropriate adapter, if required, and push it onto the valve.

3. Now, you put Spirit Z-Wave Plus on the connector.
   
   If you are not sure which valve you have, please visit: www.eurotronic.org/Service/
   FAQ Here you will find a list of various valves and adapters.

4. After succesful mounting press the green blinking button to start the adaption. Once the adaptation is completed, the display shows the setpoint temperature.

Manual operation

temperature by 0,5°C every 0,5 seconds or until the lowest temperature is set.
Press once| Increase room temperature by 0,5°C.
Press and hold| Increase Room temperature by 0,5°C and raise the Room temperature by 0,5°C every 0,5 seconds or until the highest temperature is set.
Push once|

• Confirm action which is displayed in the LCD
• Switch into Boost-Mode (Quick Heat)
• Quit Boost-mode (Quick Heat) if currently active

Hold for 3 seconds| The LCD shows the Z-Wave Node ID.
Hold for 5 seconds| The Spirit Z-Wave Plus will react to Inclusion/Exclusion Commands.
Hold while unpowered and insert batteries| Allows factory reset of the Spirit Z-Wave Plus.

Hold both simultaneously for 3 seconds| Sets or clears the Child protection.

Adapters

No adapter is required for the following valves:

Heimeier, Junkers Landys+Gyr, MNG, Honeywell, Braukmann (each with thread size M 30×1,5)| No adapter neccessary
---|---
Danfoss RAV (the pin supplied must be attached to the valve plunger)|
Danfoss RA|
Danfoss RAVL|

Warning

Remove the connecting pieces of the plastic adapter completely before you use one of the supplied adapter!

Info: For additional adaptors, please visit:
www.eurotronic.org

Removing

Exclude the Spirit Z-Wave Plus from the network before removing. Set Z-Wave Gatway in Exclusion mode. Hold the boost button for at least 5 seconds to exclude. When this process is finished, is again on the display

Unscrew the cap nut and remove Spirit Z-Wave Plus off the valve.

Help and error messages

Error

| Cause / Solution
---|---
| Batteries do not have enough power.
Replace batteries.
Heating element does not warm up.| Is the boiler water temperature O.K.? Valve does not open, is it calcified after the summer pause/heating pause?
Adjust the temperature of the boiler water. Remove the Spirit Z-Wave Plus, move the valveback and forth per hand or with a tool.
Heating element does not cool down.| Valve does not close completely. It may be that the closing point of your valve seat has shifted.
Adapt again (see “Adapting”) Move the valve stem several times by hand, it may be that adaptation is impossible because your valve is calcifi ed or the seat no longer performs its function.
ER1-ER3| The error code can be cleared by pressing the boost button.
ERR| Inclusion failed.
Z-Wave Gateway out of range.
ER1| Valve positioning not possible.
Check if the valve is jammed.
ER2| Valve not detected.

Check if the Spirit Z-Wave Plus is correctly mounted.

ER3| Valves closing point not detected. Check if the Spirit Z-Wave Plus is correctly mounted.

LEGAL NOTICE

Environmental protection:

rom the date of implementation of European guidelines 2012/19/EU into national law, the following applies: Electric and electronic devices and batteries may not be disposed of in household waste. The consumer is obliged to return electric and electronic devices and batteries to the public collection points established for them or to the point of sale. The particulars of this are regulated by the applicable state laws. The symbol on the product, operation instructions or packaging points to these provisions. You make an important contribution to the protection of the environment by reusing or recycling old equipment/batteries or making use of them in other ways.

Declaration of conformity:
Hereby, Eurotronic Technology GmbH declares that the Spirit Z-Wave Plus Radiator Thermostat is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://eurotronic.org/service/downloads.
Z-Wave and Z-Wave Plus are registered trademarks of Sigma Designs and it is subsidiaries in the United States and other countries.

Warranty

The two-year warranty begins on the day of purchase. Please keep the receipt as evidence of purchase in the future. During the guarantee period, defective radiator thermostats may be sent to the service address below. Please ensure sufficient postage is paid.
A new or repaired device will then be sent to you free of charge. Following expiry of the guarantee, you may still send the defective device to the address below for repairs. Please ensure sufficient postage is paid. Repairs carried out after the guarantee period are subject to a charge. Your legal rights are not affected by this guarantee.
There is no new warranty period starting when repairing or replacing the device. Please note that we only grant warranty on the function of the device. We will not grant warranty for the interaction between the thermostat and the bottom part of the valve. The technical data is only valid for the use of the following valves: Heimeier, Junkers Landys + Gyr, MNG, Honeywell, Braukmann (measure of thread M30 x 1,5), Oventrop (M30 x 1,5) Danfoss RA, RAV and RAVL.
Please see the combinations of the devices on our website (www.eurotronic.org/FAQ Adapter list) Eurotronic does not issue a guarantee when using the thermostat with valves which are not mentioned above.

Technical specifications

Technical modifications are subject to change.

References

• Home | EUROTRONIC Technology GmbH
• Downloads | EUROTRONIC Technology GmbH
• Home | EUROTRONIC Technology GmbH
• FAQ | EUROTRONIC Technology GmbH
• Service | EUROTRONIC Technology GmbH
• Downloads | EUROTRONIC Technology GmbH

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>