SAFEGUARD SUPPLY SS-FIREBELL-12V DC Indoor Firebell Buzzer Owner’s Manual
- June 5, 2024
- SAFEGUARD SUPPLY
Table of Contents
SAFEGUARD SUPPLY SS-FIREBALL-12V DC Indoor Fireball Buzzer
The 12V fire alarm bells sold by Safeguard Supply are meant to be used as signaling devices in conjunction with the ERA-DCRX desktop chime receiver. This device is not intended to be connected to an alarm indicating circuits of UL-listed fire alarm control panels. Although the device may be used for other purposes, Safeguard Supply markets this product as an accessory to our chime receivers
Features
-
12V DC
-
Iron base
-
Operating voltage limit: 9-16V
Maximum current: 50mA -
Operating temp: 14F-131F
-
Outdoor rated
-
Approximately 90 dBA
Mounting the Fire Bell
- Use included wrench to remove the hex bolt on top of the bell cover and take out the bolt.
- Remove the bell cover from the base to access wiring and mounting holes (see figure 1).
- Mount the unit.
- Wire the circuit and observer polarity (see figure 2).
- Replace the bell cover. (see figure 1)
- Secure the cover using the hex bolt.
Wire to Receiver
-
Figure 3 shows a sample
-
configuration of this fire
bell to the 12V DC -
the output of the ERADCRXS receiver. Please
-
consult the receiver’s
-
manual for receiver
-
settings.
WARRANTY
Safeguard Supply warrants this product to be free of defects in material and
workmanship for a period of one year from the date of purchase. This warranty
does not cover damage resulting from accident, abuse, an act of God, or
improper operation. If this product does become defective, simply return it to
Safeguard Supply. Please include a note describing the troubles along with
your name and return address as well as the original sales receipt. If the
product is covered under warranty it will be repaired or replaced at no
charge. If it is not covered by warranty, you will be notified of any charges
before work is done.