GENIE GICT390-1BL One-Button Remote Control with Intellicode Instructions
- June 5, 2024
- GENIE
Table of Contents
GENIE GICT390-1BL One-Button Remote Control with Intellicode
INSTUCTION
STEP 1
Locate and press the “Learn Code” button next to the radio signal indicator on the power head receiver of the door opener. The indicator will begin blinking twice per second.
STEP 2
Press the button on the replacement GICT390 transmitter once within thirty seconds (or press any one of the buttons, for the three-button model). The radio signal indicator wilf sta,y solidly lit.
STEP 3
Press the same button again , also with in thirty seconds. The radio signal indicator will go out and the transmitter is programmed to the door opener. If more than thirty seconds passes, or if you press a different button, the indicator will blink rapidly and the process will be halted. Repeat the process if this occurs.
⚠ WARNING
In order to prevent SERIOUS INJURY or Death from a moving gate door.
- Keep remote control out of reach of children.
- Only use the remote control when the gate/garage door can be seen clearly, is property adjusted, and there are no obstructions to door travel.
- Keep the gate/garage door in slight until it is completely closed.
Do not allow anyone to cross paths with the gate/garage door while moviing or operating the remote control.
Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>