Gaze Art Lighting 1011 LED Light User Manual
- June 5, 2024
- Gaze Art Lighting
Table of Contents
Gaze Art Lighting 1011 LED Light
UNIT SPECIFICATIONS
-
Number of LEDS: 12RGB+9W LED Lifetime: 50,000+ hours Battery Type: Rechargeable
-
Battery Power: 2 000 MAH Battery Voltage: 3.7 V Energy Consumption:4.2 W Charging Method: Induction
-
Remote Control: Infra-red Input: 100-240V AC-S0/60Hz Output: DC7.SV 0.6A
MATERIAL
- Plastic: PE
PACKAGE INCLUDES:
- l LED Light
- l Single Charger
- l Remote Control
- l Adapter
IP68 Rating
- Protected from total dust ingress.
- Protected from long term immersion up to a specified pressure.
FIRST USAGE PRECAUTIONS
** To guarantee the maximum life of your product, please follow the first
usage
PRECUATION:**
- Connect the charger
- Fully charge your lamp’s battery by placing the lamp on the charger for at least 10 hours. While the lamp is charging the light indicator on the charger will appear A green luminous indicator indicates the lamp is fully charged.
It is recommended that you empty (discharge) the full capacity of the battery before recharging fully. The internal battery has a charge accumulator and will require 8 or 10 complete charges/discharges before reaching optimal charge capacity. To preserve the long life of the battery, turn the light off while on the charging plate.
17 PROGRAMMED COLORS
RECYCLING
Do not throw this lamp away with your regular household garbage. Contact the appropriate service within your community to learn the best way to dispose of the device. Electrical products contain substances harmful to human health and the environment so must be adequately recycled.
YOUR TABLE TOP LIGHT
INFRARED REMOTE CONTROL
RECHARGING
The MINI Charger, charges one single lamp and operates with the following adapter:
- INPUT : 100V-240V-50/60Hz 0.2A Max
- OUTPUT: **7.5** vole 600mA
To preserve the long life of the battery, turn the light off while on the charging plate. When the lamp is charging the indicator will appear red. Once the lamp is fully charged the indicator will turn green.
CLEANING YOUR LAMP
**** It is recommended to clean your lamp with a soft humid cloth. Do not use any aggressive liquids or materials.
CAUTION
- Do not use the charger near a heat source or any open
- The IP waterproof level cannot be maintained during charging.
- Do not charge or store the lamp in a humid or aqueous place.
- Do not try and open or dismount the lamp or charger to avoid any risk of electrical shock or altering its waterproofing
- Do not connect lamp to any other device
- Do not try to charge the lamp with a charger other than the charger provided
- Do not try and replace battery.
- Keep charger and lamp out of reach of young children.
- When storing your lamp, put it in its original box to avoid any
WARRANTY
- Manufacturer’s Warranty: 1 Year
FCC Warning
**** This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.