VALERA 658.01 ABSOLUT ZERO CLIPPER Hair Tripper Instruction Manual
- June 5, 2024
- Valera
Table of Contents
VALERA 658.01 ABSOLUT ZERO CLIPPER Hair Tripper
PERATING INSTRUCTIONS – Original instructions
Type 658.01
Read these instructions carefully before using the appliance.
Available also onwww.valera.com
**WARNINGS
**
- For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
- Make sure the unit is perfectly dry before using it.
- WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
- This appliance can be used by children from 8 years of age and over, and by persons with limited physical, sensory or mental abilities or who lack the relevant experience and knowledge, if they are suitably supervised or have been educated to use the appliance safely and made aware of the associated risks.
- Do not allow children to play with the appliance.
- Children must not perform cleaning and maintenance procedures unless supervised.
- Do not use your unit if it is not working properly. Do not try to repair this electrical unit yourself, rather contact an authorized technician. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard.
- When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off.
- Only connect this unit to alternating current and check that the mains supply voltage corresponds to that indicated on the unit.
- Always switch off the appliance after use and disconnect the plug from the mains power socket. Do not remove the plug from the mains power socket by pulling the cable.
- Do not pull the plug out of the power supply socket when your hands are wet.
- Before switching on the appliance, always check its conditions and also control the transformer and power cable.•The elements used to pack the unit (plastic bags, cardboard box, etc.) must be kept out of reach of children as they are a potential danger to them.
- This unit must only be used for the purposes for which it is expressly intended. Any other use is to be considered improper and therefore dangerous. The manufacturer accepts no responsibility for damage caused by improper or erroneous use.
- Do not expose the appliance to temperatures below 0°C or above 40°C. Avoid exposing the appliance to direct and prolonged sunlight.
- Do not leave the appliance on charge in wet places and do not recharge the appliance when it is wet.
- The appliance comes equipped with a Li-ION battery. To help protect the environment, the batteries should not be included withordinary domestic waste, but should be taken to a special collection point instead.
- Have the battery removed by qualified technical personnel or by the treatment and recycling centre.
- Do not expose the battery to liquid, moisture or high humidity
- Keep the battery away from magnetic fields, sources of heat and naked flames.
- Danger of scratches or cuts. Do not use a comb or a set of blades if they are damaged. Replace them immediately, as they may cause injury.
- Take care not to scratch the skin when handling the appliance with the set of blades without combs.
- The A-weighted sound pressure level of the hair clipper for professional use is below 70 dB(A).
USE
COMPONENTS
- Hair clipper
- Set of blades for hair, 42 mm
- On/off switch
- Socket for transformer
- Charge monitor indicator light
- Hanging loop
- Transformer
- Guide combs: cutting length 1.5-3-4.5 mm
- Cleaning brush
- Lubricating oil
The appliance can operate either using mains power or in cordless mode, as it has a rechargeable battery
MAINS POWER SUPPLY
Connect the transformer the (fig. 1- ref. 7) by inserting the plug into the
appliance socket (fig. 1 – ref. 4).
Plug the transformer into the mains.
Warning: if the appliance does not work with mains power when the battery charge has run down completely, switch it off, recharge the battery for about five minutes and then switch back on again, running on mains power.
BATTERY OPERATION
- During normal operation the blue indicator light comes on (fig. 1 – ref. 5).
- Recharge the battery when the indicator light (fig. 1 – ref. 5) flashes red.
- When the battery is fully discharged, the appliance automatically switches off.
RECHARGING THE BATTERY
- Switch off the appliance using the switch (fig. 1 – ref. 3). The battery can only be charged when the appliance is switched off.
- Connect the transformer (fig. 1 – ref. 7) by inserting the plug into the appliance socket (fig. 1 – ref. 4).
- Plug the transformer into the mains.
- During recharging the blue indicator light comes on (fig. 1 – ref. 5).
- When the product has finished charging the blue indicator light (fig. 1 – ref. 5) flashes.
- When the battery is fully charged, the appliance can be used up to 120 minutes without connection to the mains.
- After a certain number of operating hours, charge duration in cordless mode may decrease significantly.
- The maximum charge level is reached after 4 – 5 recharging procedures.
CUTTING WITH GUIDE COMBS
Depending on the type of cut desired, the appliance can be used with or without a guide comb (fig. 1 – ref. 8). Guide combs are used to achieve different cutting lengths ranging from 1,5 to 4,5 mm.
FITTING AND REMOVING THE GUIDE COMB
- Switch off the appliance.
- When fitting the comb, refer to fig. 2A and B.
- When removing the comb, refer to fig. 2C.
CHANGING BLADES
- Switch off the appliance.
- To remove the blades, push them out of their slot as shown in fig. 3A.
- To replace the blades, first insert the rear part into the slot (fig. 3B), then push on the front to close it (fig. 3C).
- IMPORTANT: before fitting the blade, make sure that the motor pin (fig. 5 – ref. 1) is adjusted so that it can slot into the space on the inner side of the blade (fig. 5 – ref. 2).
CARE AND MAINTENANCE (fig.3, 4 and 5).
The cleaning and maintenance procedure must be carried out after every use.
- Switch OFF the appliance and disconnect it from the mains supply before performing any maintenance or changing any parts.
- Never immerse the appliance in water!
- After every use, remove the guide comb then use the small brush to eliminate any hair from the cutting head and its seat.
- Clean the outside of the appliance with a soft cloth (slightly damp if necessary). Never use solvents or abrasive detergents!
- Remove the cutting head (fig. 3) and evenly oil the blades and the seat of the motor pin which is located on the inside (fig. 5, rif. 1 and 2).
- If after prolonged use, and despite regular cleaning and lubrication, the cutting ability of the appliance appears to be diminished, the cutting head must be replaced.
ADAPTER’S TECHNICAL SPECIFICATION
ZZU1001-200040-2E
ZZU1001-200040-2U
Input: 100-240V~ 50/60 Hz 0.5A Max
Output: +4.0VDC 2.0A 8.0W
Manufacturer declared average active efficiency: > or = 78.0%
Manufacturer declared No-load power consumption: < or = 0.07W
DISPOSAL
The appliance must be disposed of in compliance with applicable environmental standards.
_This appliance conforms to European Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, 2015/863/EU, 2009/125/EC, 2012/19/EU and Regulation (EU) N. 2019/1782.
_
GUARANTEE
VALERA guarantees the appliance you have bought at following conditions:
- The guarantee conditions for this appliance are as defined by our dealer in the country of sale. In Switzerland and the countries of the European Union, the warranty period is 24 months if the final purchaser is a private person (domestic use) and 12 months if the final purchaser is a company or business or professional (professional use). The guarantee period starts from the date of purchase as stated on the present guarantee card regularly filled out and stamped by the dealer or on the sale’s invoice.
- The guarantee is applicable only against submission of the present guarantee card or the sale’s invoice.
- The guarantee covers the elimination of all defects arisen during the guarantee period resulting from proven faults in material or workmanship. The elimination of the defects will be made either by repairing the appliance or exchanging it. The guarantee does not cover any damage arising from incorrect connection to the power supply, improper use, breakage, normal wear and non-compliance with the Instructions for Use.
- All other claims of any nature, including those for eventual damages outside of the appliance, are excluded, unless our liability is legally mandatory.
- The guarantee service is carried out free of charge; it does not affect the expiry date of the guarantee.
- The guarantee becomes void if repairs are undertaken by unauthorized persons.
For UK only: this guarantee in no way affects your rights under statutory law.
In case of defect, please return the appliance well packed and together with
the guarantee card regularly dated and stamped to one of our Valera Service
Centres or to the dealer who will send it to the official importer for the
guarantee service.
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
SERVICE CENTERS
CH
VALERA – Service
Via Ponte Laveggio, 9
6853 Ligornetto / Mendrisio
Other countries
www.valera.com/service
Documents / Resources
|
VALERA 658.01 ABSOLUT ZERO CLIPPER Hair
Tripper
[pdf] Instruction Manual
658.01 ABSOLUT ZERO CLIPPER Hair Trimmer, CLIPPER Hair Trimmer, Hair Trimmer
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>