Valera 533 Bath Dryer Action Super Plus 1200 Instruction Manual
- June 13, 2024
- Valera
Table of Contents
533 Bath Dryer Action Super Plus 1200
Instruction Manual
533 Bath Dryer Action Super Plus 1200
Guarantee card
Stamp and signature of delear
INSTRUCTIONS FOR USE AND INSTALLATION
Hairdryer
Wall holder
Mod. Nr.
Date of purchase
Name and full address of purchaser
Ligo Electric SA – 6853 Ligornetto / Mendrisio – Switzerland
ASSEMBLY AND OPERATING INSTRUCTIONS
Original instructions
Read these instructions thoroughly. Available also on
www.valera.com
CAUTION
- For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
- Make sure the electrical system is fitted with a device which guarantees omnipolar disconnection from the electricity mains under category III overvoltage conditions.
- Make sure the unit is perfectly dry before using it.
- WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
- This hairdryer must be fixed so that a person taking a bath or shower cannot reach the handle, considering the cord at maximum extension.
- This appliance can be used by children from 8 years of age and over, and by persons with limited physical, sensory or mental abilities or who lack the relevant experience and knowledge, if they are suitably supervised or have been educated to use the appliance safely and made aware of the associated risks.
- Do not allow children to play with the appliance.
- Children must not perform cleaning and maintenance procedures unless supervised.
- Do not use your unit if it is not working properly. Do not try to repair this electrical unit yourself, rather contact an authorized technician. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard.
- Plug the hairdryer into an alternating current outlet only, and make sure that the voltage of your electricity supply is the same as that indicated on the rating plate of the appliance.
- Do not immerse in water or other liquids.
- Never put the appliance in a place where it could fall into water or in other liquids.
- Do not try to salvage an electrical appliance which has fallen into water.
- Turn the unit off when you put it down.
- Unplug the appliance when not in use, but never do it by pulling the cord.
- Allow your appliance to cool before storing away and do not wrap the supply cord around the hairdryer in storage.
- The A-weighted sound pressure level of the hairdryers for commercial use is below 70 dB(A).
- Designation of the appliance (see technical product specifications) WALL-MOUNTED HAIRDRYER FOR COMMERCIAL USE
INSTALLATION INSTRUCTIONS
Wall holder for hairdryer
Type 036 – 038A – 038B
Type 036
Front housing model.
Type 038A
Vertical housing model.
Type 038B
As the 038A but with no switch.
Installation of wall holder
This wall holder must only be installed by a qualified electrician in
conformity to applicable safety standards.
The wall holder may be installed in one of two ways:
A = for fixed connection lead
B = for mobile connection lead
Attention: before installing the wall holder always switch off the general
switch of your mains electricity.
For each pole a switch with a minimum break distance between contacts of 3 mm
must be fitted up-line of the appliance.
Each time the appliance is opened, the switch must be used to disconnect the
appliance.
The connection wiring must be at least type H05VV-F 2×1,0 mm².
Method A
IMPORTANT: Refer to the figures for the model you have purchased.
-
Unscrew the screw (1) (fig. 1) and remove the cover from the wall unit.
-
Break the plastic membrane (3) at the back of the wall unit (fig. 3A).
-
Route the main power cable from the wall (4) through the hole left by the plastic membrane (3) (fig. 3A).
-
Fix the back of the wall unit to the wall using the fixing screws and wall plugs provided (fig. 2).
-
Remove the terminal strip (5). The input power cable (4) and the output power cable (9) of hairdryer with max input current of 10A, if not already connected, must be connected to the terminal strip(5).
In mod. 036 the Neutral output cable(9) must be connected to terminal strip(5) and the Line output cable (9) to terminal strip (11). -
Reposition the terminal strip. Tighten the cable clamp (6 and 10) with its own screws. (fig. 3A). IMPORTANT: This appliance is double insulated and has no ground (earth) connection.
-
Fit the cover back on the wall unit with (1) (fig. 1).
-
Switch the power on at the mains switch. The hair dryer is now ready to use.
Method B
IMPORTANT: Refer to the figures for the model you have purchased.
-
Unscrew the screw (1) (fig. 1) and remove the cover from the wall unit.
-
Break the plastic membrane (7) (fig. 3B).
-
Fix the back of the wall unit to the wall using the fixing screws and wall plugs provided (fig. 2).
-
Route the input power cable (8) and the output power (9) into the holes (fig. 3B).
-
Remove the terminal strip (5). The input power cable (8) anf the output power cable (9) of hairdryer with max input current of 10A,if not already connected, must be connected to the terminal strip(5).
In mod. 036 the Neutral output cable(9) must be connected to terminal strip (5) and the Line output cable (9) to terminal strip (11).
Reposition the terminal strip. Tighten the cable clamp (6 and 10) with its own screws. (fig. 3B), IMPORTANT: This appliance is double insulated and has no ground (earth) connection. -
Fit the cover back on the wall unit with (1) (fig. 1).
-
Switch the power on at the mains switch. The hair dryer is now ready to use.
INSTRUCTIONS FOR USE
Hairdryer with wall holder
Control Switches
Control switch on wall holder only for models equipped with a switch) rif. 2
fig. 1: fonty oHon quipp ) 9.
Hairdryer
Type 533.03 – 533.05 – 533.03/I – 533.05/1
542.05 – 542.06 – 542.14 – 561.22
Pushbutton: ON=On/Off
(pressure must be maintained to operate the hairdryer)
Slide Switch
Cool=(low power)
1=(medium power)
2=(maximum power)
Hairdryer
Type 533.04 – 533.06 – 533.14 – 533.15 554.01 – 554.04 – 554.07 – 554.10
Pushbutton =On/Off
(pressure must be maintained to operate the hairdryer)
Hairdryer
Type 554.03 – 554.06 – 554.09 – 554.12
Slide Switch
0=(OFF)
1=(low power)
2=(maximum power)
Hairdryer Mod. 561.02 – 561.17 – 561.20 1.22
Pushbutton ON = On/off (pressure must be maintained to operate the hairdryer)
Left switch
0 = Off
1 = Low air speed
2 = High air speed
Right switch
Cool = Low air temperature
1 = Medium air temperature
2 = High air temperature
PRODUCT CARE
When not in use, the mains switch on the wall holder should be in the “Off”
position. The hairdryer requires no special care or attention.
You can clean your appliance with a cloth dampened with water. The cleaning of
hairdryers with detergents, solvents, alcohol and other chemical products is
strictly prohibited.
When necessary, the air inlet grill should be cleaned with a soft brush or by
vacuum cleaner.
Important
This hairdryer conforms to the safety regulations regarding electrical
appliances. This hairdryer has a safety cut-out which will operate in case of
overheating. The dryer will reset itself after being left to cool for a few
minutes, but please check air inlet and outlet grills are clear before
continuing to use the dryer.
This appliance conforms to European Directives 2014/30/EU, 2014/35/EU, 2009/125/EC and Regulation (EC) No. 1275/2008.
GUARANTEE
VALERA guarantees the appliance you have bought at following conditions:
- The guarantee conditions for this appliance are as defined by our dealer in the country of sale. In Switzerland and in the countries subject to the European directive 44/99/CE the guarantee period is 24 months for domestic use and 6 months for professional or similar use. The guarantee period starts from the date of purchase as stated on the present guarantee card regularly filled out and stamped by the dealer or on the sale’s invoice.
- The guarantee is applicable only against submission of the present guarantee card or the sale’s invoice.
- The guarantee covers the elimination of all defects arisen during the guarantee period resulting from proven faults in material or workmanship. The elimination of the defects will be made either by repairing the appliance or exchanging it. The guarantee does not cover any damage arising from incorrect connection to the power supply, improper use, breakage, normal wear and non-compliance with the Instructions for Use.
- All other claims of any nature, including those for eventual damages outside of the appliance, are excluded, unless ou( liability is legally mandatory.
- The guarantee service is carried out free of charge; it does not affect the expiry date of the guarantee.
- The guarantee becomes void if repairs are under-taken by unauthorized persons.
For UK only: this guarantee in no way affects your rights under statutory
law.
In case of defect, please return the appliance well packed and together with
the guarantee card regularly dated and stamped to one of our Valera Service
Centres or to the dealer who will send it to the official importer for the
guarantee service.
The symbol **** on the product or on its packaging indicates that this product
may not be treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this
product. For more detailed information about recycling of this product, please
contact your local city office, your household waste disposal service or the
shop where you purchased the product.
VALERA is a registered trade mark of Ligo Electric S.A. – Switzerland
WARNING
The hairdryers listed in these instructions for use are NOT suitable for installation or use in public areas, gyms, wellness/ fitness centres, clubs, spas, etc. with high or low frequency of users.
They are only suitable for installation and use in private rooms/bathrooms in hotels, guesthouses, homes and ship’s cabins.
SERVICE CENTERS
CH
CH VALERA – Service
Via Ponte Laveggio, 9
6853 Ligornetto / Mendrisio
Other countries www.valera.com/service
Mod. Nr.
Date of purchase
Name and full address of purchaser
Made by Ligo Electric SA – Via Ponte Laveggio, 9
6853 Ligornetto / Mendrisio – Switzerland
Valera is a registered trademark of Ligo Electric S.A. – Switzerland ****
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>