wallas 270 Stoves and Ovens Instruction Manual

: June 3, 2024
: wallas

Table of Contents

Installation
Package contents
Warranty Terms for Recreational Use
Spare parts
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

270 Stoves and Ovens
Instruction Manual wallas 270 Stoves and Ovens

Installation

270 & 85DU
Remove unnecessary parts.
Remove four screws (1).
Remove the back plate (2).
Save or discard items, these are not used with the 270 blower lid.

wallas 270 Stoves and Ovens - Figure 1

Installation of 270 blower unit
Unpack the blower unit.
Place the blower lid on a soft flat surface as shown in the picture. Be careful not to scratch the surface.

wallas 270 Stoves and Ovens - Figure 2

Package contents

270|
---|---
1 pcs| Blower lid
1 pcs| Accessory bag 17695
4 pcs| Fastening screw M4 x 12 mm
3 pcs| Cable tie
1 pcs| Installation, operation, and service instructions
1 pcs| L-shape cover list for installation hole

Place the 85DU onto the blower unit as shown in the picture below.
Install and tighten M4x12 screws (4 pcs) (supplied with blower unit). wallas
270 Stoves and Ovens - Figure 3

Connect the cable between 85DU and 270
Remove the connection cable from the printed wire board (older version) or remove the shortcut piece from the printed wire board.
Connect the blower lid to the printed wire board (to the place where you removed the old connector).
Use a cable tie to fasten the cable.

wallas 270 Stoves and Ovens - Figure 4 wallas 270
Stoves and Ovens - Figure 5

CUTOUT dimensions for Blower lid 270 with 85DU
Cut extra space needed for the blower lid (lined area). Clue the L-shape profile to the edge of the hole.

wallas 270 Stoves and Ovens - Figure 7

Minimum size of the replacement air opening
After the installation of Blower Lid 270 needed replacement amount of air will rise.
The minimum surface area for replacement air openings is 150 cm2.

wallas 270 Stoves and Ovens - Figure 8

Warranty Terms for Recreational Use

Wallas-Marin Oy (the manufacturer) shall be liable for any defects in the raw material or manufacture of the products and items sold by the importer for 24 months from the day of sale on the following conditions.
The warranty can be extended by a further 12 months by registering the product in the website of WallasMarin Oy (www.wallas.fi) within three (3) months of the unit being sold to the end customer.

In the event of a defect:
a) Look at the checklist on the website or installation/usage manual (www.wallas.fi) to make sure the defect in question is not related to use. A simple problem might not be covered by the warranty ie. water in diesel or unit requires service.
b) Notification of the defect must be given in writing immediately, if possible, but no later than two (2) months after the appearance of the defect. After the warranty period ends, a referral back to a notification at the time of the warranty period is not valid unless the notification was made in writing.
A valid receipt or another reliable official document from the time of purchase is required for proof of warranty eligibility.
c) For repairs under warranty, the customer must take the product to the place of purchase (the seller is responsible for handling units with warranty issues), to an authorized repair shop, or to the Wallas-Marin Oy factory service.
Warranty service must be done by authorized Wallas repair personnel. The warranty does not cover costs for the removal and reinstallation of the device or for any damage in transit of a device that has been sent for repair.
The warranty does not include any transport costs. (Wallas is a return to base warranty).
d) The customer must provide the following information in writing for warranty service:
• description of the problem.
• a description of where and how the device was installed (photographs of the installation may help)
• product type and serial number, place, and date of purchase
This warranty is not valid in the following cases when:
• failure occurs as a result of components, which are not approved by the manufacturer, have been added to the device, and/or, it’s structure has been modified without the consent of the manufacturer.
• the instructions for installation, operation or maintenance have not been followed.
• storage or transport has been inappropriate.
• a problem has resulted from an accident or damage, which Wallas has had no control over (force majeure).
• problems arise from normal wear and tear. Wearing parts include: glow coil/plug, combustion/blower motors (warranty limit 2000 running hours), bottom matt, fuel needle, fuel pump and fuel filter, seals
• the product has suffered from improper handling, unsuitable fuel, low voltage, excess voltage, damage due to dirt, water penetrating into the unit, or corrosion
• the device has been opened without the explicit permission of the factory/importer
• components, other than original Wallas spare parts or components, have been used in the repair of the device.
• repair by an unauthorized service company
Repairs carried out during the warranty period do not renew or alter the original warranty period.
Indirect damages arising from a defective product are not covered by this warranty.
This warranty is only valid for boat products that have been installed in boats and for cottage products that have been installed in cottages. The warranty does not cover Wallas products installed in vehicles or other areas.
This warranty does not limit rights specified in consumer protection legislation.