PRODVX GM-75 Glass Mount Instruction Manual
- June 12, 2024
- Prodvx
Table of Contents
PRODVX GM-75 Glass Mount
ProDVX GM-75 Glass Mount
Thank you for choosing the ProDVX GM-75 Glass Mount. This is a step-by-step instruction manual to successfully install the ProDVX GM-75 Glass Mount for your 10″ display. The ProDVX GM-75 Glass Mount contains the following parts:
- 1 x Glass Mount Cover Sticker
- 1 x ProDVX GM-75 Mount frame
- 1 x adhesive strip
- 4 x short VESA screws
- 2 x safety screws
Please contact [email protected] if you need additional support.
Applying the Glass Mount Cover Sticker
- Clean the surface, preferably with Pro-Screen Cleaner spray.
- Affix the Glass Mount Cover Sticker to the glass where the tablet will be placed.
- Use a solid straight item to even out the Glass Mount Cover Sticker.
- Even out big bubbles with the straight item (little bubbles will disappear in time).
- Gently pull down the paper from the front side.
- Clean the Glass Mount Cover Sticker with Pro-Screen Cleaner spray and let it dry for ten minutes
Mounting your device
-
Remove the white paper from the adhesive strip and attach it to the backside of the ProDVX GM-75 Mount frame. Then wait for 15 minutes.
-
Remove the red paper from the adhesive strip and press the ProDVX GM-75 Mount frame firmly onto the Glass Mount Cover Sticker. Hold it for one minute.
Note : Before mounting and turning on the device, wait for 2-3 hours to allow the adhesive to take hold. At room temperature, approximately 50% of the ultimate strength will be achieved after 20 minutes, 90% after 24 hours, and 100% after 72 hours. -
Screw the four VESA screws into the VESA holes of your 10″ display. Tighten them by hand so that they stick out a few millimeters for affixing into the keyholes.
-
Align the screws on the back of the device with the four large keyholes on the ProDVX GM-75 Mount frame and slide from left to right until you hear a click!
-
Insert the two included safety screws into the top of the mounting plate. This will lock the mounting screws into place.
For more information, scan the QR code:
