wallas 220D Heat Blower Lid Installation Guide
- June 9, 2024
- wallas
Table of Contents
wallas 220D Heat Blower Lid
Installation Instructions
- Remove the connection cable from printed wire board (older version) or remove the short circuit piece from printed wire board.
- Connect blower lid to printed wire board (to the place where you removed the old connector).
-
This short circuit loop is attached into the heat blower lid power cord coming from the PCB.
-
Remove the short circuit loop, and throw it away.
-
Take the female plug from the 220D heat blower lid.
-
And plug it to heat blower lid power cord PCB.
-
You have done your wire setup for 220D, if it looks like this..
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>