DENVER DAB-46 Desk Radio Instruction Manual
- June 5, 2024
- Denver
Table of Contents
DENVER DAB-46 Desk Radio
PRODUCT OVERVIEW
- LCD DISPLAY
- STANDBY/MODE BUTTON
- PREVIOUS BUTTON
- INFO/MENU BUTTON
- SCAN BUTTON
- ENTER/VOLUME KNOB(Confirm the setting/adjust the button)
- PRESET/DIMMER BUTTON
- NEXT BUTTON
- SLEEP/SNOOZE BUTTON
- ALARM BUTTON
- ANTENNA
- OFF/ON BUTTON
- HEADPHONE JACK
- DC 5V IN
- AC/DC ADAPTOR
BASIC OPERATION-GETTING STARTED
The unit can be powered either by AC power or battery. (not incl)
Operation on AC power
- Insert the DC power jack of AC/DC adaptor to the DC input socket located at the rear of the radio.
- Plug the AC/DC adaptor to the AC mains outlet.
- Slide the ON/OFF switch to ON and press the STANDBY/MODE button to turn the radio on.
Warning: Always use the supplied AC power adapter. If the AC Adaptor voltage is more than 5V, product damage or risk possibly occurs.
Operation on battery
- Ensure the AC/DC adaptor is disconnected from the unit.
- Load 4 AA batteries in the battery compartment.
- Press the STANDBY/MODE button to turn the radio on.
Note: To obtain the best performance on battery operation, use of alkaline batteries is highly recommended.
Navigation of the menu
The following controls are used to move about the menu tree to choose and
select the required settings:
Press and hold the INFO/MENU button to enter the menu options. Press the ◄ or
► button to navigate the options, then press the ENTERNOLUME knob to confirm.
Description of the menu
OPERATION OF RADIO
DAB radio
Press the STANDBY/MODE button to turn the unit on, and press the SCAN button
to search for all available radio stations. During the scan, the display show
“Full scan” together with a slide bar that indicates the progress of the scan
and the number of stations that have been found so far (Fig.2). Once the scan
has finished, the radio broadcasts the first alphanumerically found station.
You can now press the ◄ /► buttons to select the found stations, then press
the ENTERNOLUME knob to confirm selection.
Note: If there is no station found after auto scan, the radio will
display “No Station”. In this case, adjust the position of the antenna and
relocate the unit for better signal reception. 
FM radio
- To select FM, press the STANDBY/MODE button. The display shows FM and the frequency.
- To activate auto search, press and hold the SCAN button until the radio starts to scan. The scan stops automatically once a FM station has been found.
- To search manually, press repeatedly the ◄ /► button to tune to a radio station. If the reception is poor, adjust the position of the antenna and relocate the unit for better signal reception.
FM scan via menu
In FM mode, press and hold the INFO/MENU button to enter the menu, and press
the /► button to select “FM scan setting” (Fig.3), then press the ENTERNOLUME
knob to enter the sub-option. Then press the ◄ /► button to select “Only
USING HEADPHONES
A stereo headphone jack is available on the unit. Plug your earphones or
headphones (not supplied) to the jack marked(“), and adjust the volume to the
reasonable listening level. The speakers of the unit are disabled for output
while earphones or headphones are inserted.
Warning: Excessive sound pressure from earphones or headphones can cause
hearing loss.
RESET
If you move the unit to another location or another country, the stored DAB stations may no longer be available. In this case, reset the unit to the factory settings.
- With the unit switched on, press and hold the INFO/MENU button to enter the menu, and press the ◄ /► button to select “Factory reset” (Fig.5) , then press the ENTERNOLUME knob to enter the sub-option. Then press the ◄ /► button to select “
” from the “Factory Reset Yes” option (Fig.6), and press the ENTERNOLUME knob to confirm. - The radio displays “Restarting …. “, and start searching all available radio stations.
Note: All the previously-stored radio stations are deleted after
resetting.
TECHNICAL SPECIFICATIONS
| Rated voltaae (adaptor) | AC 100 – 240V- 50/60Hz, 0.15A |
|---|---|
| Adaptor output | DC 5V, 1A |
| Rated voltaae (radio) | DC 5V or 1.5V x 4 (4 AA batteries) |
| Power consumption | 5 W |
| Audio output | 2W RMS |
| Radio | DAB 174-240MHz |
FM 87.5-108MHz
Operating conditions Temperature| 5°C to 35°C
Humidity 5% to 90%
Unit dimension| 170 (L) x 96(W) x 101 (H) mm
Weight| 0.7kg
Electric and electronic equipment and included batteries contain materials,
components and substances that can be hazardous to your health and the
environment if the waste material (discarded electric and electronic equipment
and batteries) is not handled correctly. Electric and electronic equipment and
batteries is marked with the crossed-out trash can symbol, seen below. This
symbol signifies that electric and electronic equipment and batteries should
not be disposed of with other household waste, but should be disposed of
separately. As the end-user it is important that you submit your used
batteries to the appropriate and designated facility. In this manner, you make
sure that the batteries are recycled in accordance with legislature and will
not harm the environment. All cities have established collection points, where
electric and electronic equipment and batteries can either be submitted free
of charge at recycling stations and other collection sites or be collected
from the households. Additional information is available at the technical
department of your city. Hereby, Inter Sales A/S declares that the radio
equipment type DAB-46 is in compliance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is available at the following
internet address: www.denver-electronics.com and then click the search ICON on top line of website. Write
modelnumber: DAB-46.Now enter product page, and red directive is found under
downloads/other downloads
Operating Frequency Range: DAB 174-240MHz