Gear4music SZSW-D10S SUBZERO PA SUBWOOFER User Manual

June 5, 2024
Gear4music

SUBZERO PA SUBWOOFER
SZSW-D10S/D12S/D15S
USER MANUAL

WARNING!
Do not open cover. No user-serviceable parts inside. Refer servicing to qualified service personnel Do not place the product in a location near a heat source such as a radiator, or in an area subject to direct sunlight, excessive dust, mechanical vibration or shock The product must not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the product No naked flame sources, such as lighted candles, should be placed on the product Allow adequate air circulation and avoid obstructing vents (if present) to prevent internal heat build-up. The ventillation must not be impeded by covering the appliance with items such as newspapers, tablecloths, curtains etc. To prevent injury, this appliance must be securely attached to the floor/wall in accordance with the installation instructions. The mains plug is used to disconnect the appliance from the mains supply. Ensure that the mains outlet is easily-accessible and remove the plug from the mains outlet if you notice any abnormality with the appliance.

INTRODUCTION

Thank you for purchasing the SubZero D10S / D12S / D15S DSP PA Subwoofer.
To get the most out of your product, please read this manual carefully.

BOX CONTENTS

  • SubZero D10S / D12S / D15S DSP PA Subwoofer.
  • UK Power Cable.
  • EU Power Cable.
  • User Guide.

PRODUCT FEATURES

  • 10″ / 12″ / 15″ driver.
  • Class D amplifier.
  • Boost function.
  • Phase reverse function.
  • Output power:
    D10S – 250W RMS / 350W Peak / 1000W Max.
    D12S – 300W RMS / 420W Peak / 1200W Max.
    D15S – 300W RMS / 420W Peak / 1200W Max.

CONTROLS & FUNCTIONS

  1. CHANNEL INPUT
    Connect the Mix Out output from a mixing desk or PA speaker to this input via either 6.3mm (1/4″) TS Jack or XLR cable.

  2. MIX OUT
    Balanced, mono summed, full range output. Connect the subwoofer to a PA speaker, or further subwoofers, using this output.

  3. LED INDICATORS
    POWER: When lit, the power is on.
    SIG: When lit, the speaker is receiving an input signal.
    CLIP: When lit, the input signal level is excessive and should be reduced.

  4. MASTER VOLUME
    Increase or decrease the volume of the subwoofer.

  5. PHASE REVERSE SWITCH
    Reverses the phase of the subwoofers output by 180º. If you find you are having problems with the bass frequencies when the subwoofer is connected to a PA speaker (such as a lack of volume, or lack of a certain low-end frequency), try using this function.

  6. BASS BOOST
    Boosts the output by 10dB.

  7. VOLTAGE SWITCH
    Changes the input voltage. Ensure this is correct for your region.

  8. POWER SWITCH
    Turns the Unit On or Off.

  9. POWER CONNECTION
    Connect the supplied power cable here.

SPECIFICATIONS

SW-D10S
Speaker Type ……………………Active
Cabinet …………………………….Painted 15mm MDF
Amplifier ……………………….. Class D DSP
RMS Power …………………….. 250W
Peak Power …………………….. 350W
Max Power …………………….. 1000W
Subwoofer ……………………….10”
Voice Coil ……………………… 2” with 40oz ferrite magnet
Impedance (total) …………. 4 Ohm
Sensitivity ……………………… 95dB
Max SPL rating …………….. 122dB
Frequency response ……… 60Hz-150Hz
AC power input ……………. 110-120V / 220-240V,50/60Hz
Fuse Type ……………………… 6.3A, 250V (110120V),3.15A,250V(220-240V)
Weight …………………………… 18KG
Dimensions ……………………. 435340405mm| SW-D12S
Speaker Type ………………….Active
Cabinet …………………………. Painted 15mm MDF
Amplifier ………………………. Class D DSP
RMS Power …………………… 300W
Peak Power ……………………. 420W
Max Power …………………… 1200W
Subwoofer ……………. ……..12”
Voice Coil ……………………. 2.5”VC with 50oz ferrite magnet
Impedance (total) ………….4 Ohm
Sensitivity ……………………. 96dB
Max SPL rating ……………. 124dB
Frequency response ……… 55Hz-150Hz
AC power input ………….. 110-120V / 220-240V, 50/60Hz
Fuse Type ……………………. 6.3A, 250V (110120V),3.15A,250V(220-240V)
Weight …………………………. 21KG
Dimensions ………………… 480380450mm
---|---

SW-D15S
Speaker Type ………………….Active
Cabinet …………………………. Painted 15mm MDF
Amplifier ……………………… Class D DSP
RMS Power ………………….. 300W
Peak Power ………………….. 420W
Max Power …………………… 1200W
Subwoofer …………………….15”
Voice Coil ……………………. 3”VC 60OZ ferritemagnet
Impedance (total) ………….4 Ohm
Sensitivity …………………….. 96dB
Max SPL rating …………….. 124dB
Frequency response ………. 50Hz-150Hz
AC power input ……………. 110-120V / 220-240V,50/60Hz
Fuse Type ……………………….6.3A, 250V (110120V),3.15A,250V(220-240V)
Weight …………………………… 29KG
Dimensions …………………… 565450540mm

KETTLESTRING LANE
YORK YO30 4XF UNITED KINGDOM
If you have any more questions about this product, please do not hesitate to contact the Gear4music Customer Service Team on: +44 (0) 330 365 4444 or info@gear4music.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals