Elinta Charge CCV222COM CityCharge User Manual

Elinta Charge CCV222COM CityCharge

To start charging

1. Connect charging cable to electric vehicle;
2. Connect charging cable to charging station;
3. Put the RFID identification card to the right place. The charging will start after few seconds.

LED strips indicate status of charging station

• Blue – ready / charging finished;
• Red – the station is busy / charging electric vehicle.
  Charging cable is locked during the vehicle charging. When the vehicle is fully charged the charging stops automatically, or it can be stopped by using RFID identification card.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(5). Operation is subject to the following wo conditions:1. This device may not cause interference. 2.This device must acept any interference, including interference that may cause undesired operation of the device.

User changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Elinta Charge, UAB Partizanu g. 63M, Kaunas 50306 Lithuania
Tel.: +370 615 71604 info@elintacharge.com www.elintacharge.com

References

• ElintaCharge – Electric vehicle charging stations and accessories.
• ElintaCharge – Electric vehicle charging stations and accessories.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>