Sanyo SHBN 2AVOZ Module of Wireless Pistol Tool User Manual
- June 5, 2024
- SANYO
Table of Contents
Sanyo SHBN 2AVOZ Module of Wireless Pistol Tool
Since this module is not sold to general end-users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure).
The following information must be indicated on the host device of this module;
for FCC
-
Contains Transmitter Module FCC ID: 2AVOZ-SHBN
or -
Contains FCC ID: 2AVOZ-SHBN
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. If it is difficult to describe this statement on the host device due to the size, please describe in the user’s manual and also either describe on the device packaging or on a removable label attached to the device.
for ISED(IC)
Contains IC: 26102-SHBN
The following statements must be described on the user manual of the host device of this module;
for FCC
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This device complies with below part 15 of the FCC Rules.
- Part 15 Subpart C
- Part 15 Subpart E
The modular transmitter is only FCC authorized for the specific rules parts (i.e., FCC transmitter rules) listed on the grant, and the host product manufacture is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body .
Antenna List
| Model No. | Antenna Type | Antenna Gain |
|---|---|---|
| H2B1PC1A1C | PCB | +1.8dBi (2.4GHz), +3.9dBi (5GHz) |
| SXANTFDB24A55 | PCB(On board) | +2.1dBi (2.4GHz), +2.2dBi (5GHz) |
ISED(IC)
for indoor use only
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF)
Exposure rules. This equipment should be installed and operated keeping the
radiator at least 20cm or more away from person’s body.
This radio transmitter (26102-SHBN) has been approved by Innovation, Science
and Economic Development Canada to operate with the antenna types listed
below, with the maximum permissible gain indicated. Antenna types not included
in this list that have a gain greater than the maximum gain indicated for any
type listed are strictly prohibited for use with this device.
| Antenna type | Gain | Impedance |
|---|---|---|
| PCB | +1.8dBi (2.4GHz), +3.9dBi (5GHz) | 50 ohm |
| PCB(On board) | +2.1dBi (2.4GHz), +2.2dBi (5GHz) | 50 ohm |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>