Gude BSS 18 1-4 Inch Impact Screwdriver and LGAP 18-3020 Charger and Battery Set Instruction Manual

Gude BSS 18 1-4 Inch Impact Screwdriver and LGAP 18-3020 Charger and

Battery Set

Starting-up the machine

Operation

Technical Data

Noise details
Sound pressure level LpA| 95,1 dB (A)| 95,1 dB(A)
Sound power level LWA| 106,1 db (A)| 106,1 db (A)
Measured according to EN 60745; Uncertainty K = 3 dB (A)|
Wear ear protectors!| |
Vibration details| |
Vibration total values (triaxial vector sum) determined according to EN 60745 Impact tightening of fasteners of the maximum capacity of the tool:
Vibration emission value ah| 15,87 m/s²| 15,87 m/s²
Uncertainty K = 1,5 m/s2| |

WARNING:

• The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet.

• The vibration emission level may be used to compare one tool with another.

• It may be used for a preliminary assessment of exposure.

• An accurate estimate of the vibratory load should also take into account the times when the tool is shut down or when it is running but not actually in use.

• This may significantly reduce the vibratory load over the total working period.

• Identify additional safety measures to protect the operator from the effects of vibration such as: maintaining the tool and the accessories, keeping the hands warm, and organization of work patterns.

• Read and understand the operating instructions before using the appliance. Familiarise yourself with the control elements and how to use the appliance properly. Abide by all the safety measures stated in the service manual. Act responsibly toward third parties.

• The operator is responsible for accidents or risks to third parties.

• Persons over 16 years of age can only work on the appliance. An exception includes youngsters trained in order to reach knowledge under supervision
  of the trainer during occupational education.

• In case of any doubts about connection and operation refer please to our customer center

Specified Conditions Of Use

• The impact wrench can be used to tighten and loosen nuts and bolts.
• As a control measure, always check the tightening torque with a torque wrench.
• Do not use this product in any other way as stated for normal use. Not observing general regulations in force and instructions from this manual does not make the manufacturer liable for damages.
• In spite of compliance with all relevant design regulations, dangers may still present themselves when the machine is operated, e.g.:
  • noise emissions
  • dust emissions
  • vibrations to hand and arms

Emergency procedure

Conduct a first-aid procedure adequate to the injury and summon qualified medical attendance as quickly as possible. Protect the injured person from further harm and calm them down. If you seek help, state the following pieces of information: 1. Accident site, 2. Accident type, 3. A number of injured persons, 4. Injury type(s)

Symbols

Battery

WARNING Read all safety warnings and all instructions.  Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.

Safety information for impact wrenches

Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring. Fasteners contacting a „live“ wire may make exposed metal parts of the power tool „live“ and could give the operator an electric shock.

Additional Safety and Working Instructions

• Wear ear protectors. Exposure to noise can cause hearing loss.
• Use protective equipment. Always wear safety glasses when working with the machine. The use of protective clothing is recommended, such as dust mask, protective gloves, sturdy non-slip footwear and ear defenders.
• The dust produced when using this tool may be harmful to health. Do not inhale the dust. Use a dust absorption system and wear a suitable dust protec-tion mask. Remove deposited dust thoroughly, e.g. with a vacuum cleaner.
• Clamp your workpiece with a clamping device. Unclamped workpieces can cause severe injury and damage.

WARNING: Check all screw and plug-in connections and protective equipment if firm and tightened properly and whether all moving parts are running smooth whenever the appliance is to be put into operation.
WARNING: The appliance must not be used if damaged or safety equipment is defective. Replace any worn-out and damaged parts.

• Do not use the device near flammable liquids or gases. Risk of fire and explosion in case of a short circuit.
• Please turn the device immediately off when the tool used gets blocked! Do not turn the device on again when the tool is still blocked. This could cause a bounce back with a high reaction moment. Determine and remove the cause of the blocking of the tool used while respecting the safety instructions. The possible causes may be:
  • it is tilted in the workpiece to be machined
  • it has pierced through the material to be machined
  • the power tool is overloaded

Battery

Risk of fire! Risk of explosion!
Never use damaged, defective or deformed accumulators. Never open or damage the accumulator or let it fall on the ground.

Umgebungstemperatur

Protect the battery against heat and fire. Battery to be used at ambient temperatures between 10°C and +40°C only.
Never put the battery on heaters and do not expose it to strong sunlight for a long time. After being subject to heavy load, let the battery cool down first.
Short circuit – do not bridge the accumulator contacts with metal parts.
The accumulator must be packaged (plastic bag, box) or accumulator contacts must be sealed up for accumulator disposal, transport or storage.

The Güde charger to be used only to charge the battery. There can be malfunction or fire if different chargers are used.
Vapors may leak out in case of unauthorized use or when using a damaged accumulator. Bring fresh air and seek medical advice if experiencing difficulties. Vapors may irritate the respiratory system.

Work instructions

Accumulators are supplied partially charged and must therefore be fully charged before being used for the first time.

• Charge the accumulator when the appliance is running slowly or stops.
• A li-ion battery may be charged at any time without any shortening of its life. Charging process interruption will not damage the accumulator.
• A Li-ion battery is protected by Electronic Cell Protection against deep discharge.
• A significantly shorter operating time of a charged battery means the battery life is over and the battery must be replaced.

Dispose of the batteries in an environmentally friendly manner.
Li-ion batteries are subject to special disposal obligations. Have any defective batteries been disposed of by a specialized shop? The battery must be taken out before the appliance is scrapped. Damaged batteries may harm the environment and your health if toxic vapors or liquids leak out of such batteries. Therefore, never send a defective battery by post, etc. Please contact your local recycling center.
Dispose of the batteries when discharged. We recommend applying adhesive tape on the poles to protect them against short circuits. Never open the battery.

Maintenance

Take the replaceable battery from the appliance before any extension, cleaning or servicing works.

Repairs and works specified in these Instructions may only be performed by qualified authorized staff.
Use only original accessories and original spare parts.
Keep the device, in particular the air vents, clean at all times. Never spray water on the device’s body!
Do not clean the plastics with solvents, or flammable or toxic fluids. For cleaning, use a damp cloth only.
Only a regularly maintained and treated appliance can serve as a satisfactory aid. Insufficient maintenance and care can lead to unforeseen accidents and injuries.
If necessary, a list of spare parts can be found at www.guede.com.

GÜDE GmbH & Co. KG Birkichstrasse 6
74549 Wolpertshausen Deutschland
Tel.: +49-(0)7904/700-0 Fax.: +49-(0)7904/700-250 eMail: info@guede.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>