Shantou LHWJX555 axis-4 aircraft remote controll Instruction Manual
- June 5, 2024
- SHANTOU
Table of Contents
LHWJX555 axis-4 aircraft remote controll
Instruction Manual
AGE: 14 +
REMOTE CONTROL BATTERY INSTALLATION
- Remove the battery cover from the back of the controller (Fig. A)
- Install 4 “AA” batteries into the controller, make sure to install batteries to their correct polarity. (Fig. B) Do not mix old and new batteries or battery types.
- Replace the battery cover
THE INSTRUCTION ON LITHIUM BATTERY CHARGING
- Open the aircraft battery cover and remove the aircraft’s lithium battery from the aircraft battery compartment (Figure 1)
- Connect the lithium battery to the USB charger socket and plug the other end of the USB charger into the power port When charging, the LED will light up. ‘Arrien the charging is completed, the LED will automatically turn off, indicating that charging is complete. The charging time is about 30 minutes. (Figure 2)
- After charging is completed, install the lithium battery into the battery slot and connect it to the connector on the circuit board, taking care not to reverse the positive and negative poles. (Figure 3)
- Cover the aircraft battery cover.
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>