SHANTOU HW8008 Infrared RC Helicopter User Manual
- October 30, 2023
- SHANTOU
Table of Contents
SHANTOU HW8008 Infrared RC Helicopter
Product Information
The product complies with part 15 of the FCC rules. It has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction. The device must not cause harmful interference and must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Product Usage Instructions
- Ensure that the device is used in a portable exposure condition.
- Do not make any changes or modifications to the device without the express approval of the party responsible for compliance.
- Avoid using the device in a way that may cause harmful interference to other devices.
- If interference is received, including interference that may cause undesired operation, the device must accept it.
- Follow all applicable FCC rules and regulations when operating the device.
Helicopter
Remote control
Battery Installation
Remote control battery installation
Open the battery cover, install 3 AAA batteries correctly according to the electrode instructions in the battery box, and then cover the battery cover.
Thank you for choosing “Infrared RC Helicopter” system.It is manufactured to the highest quality standards and we hope that it will give you many years of trouble-free use. As with any fine instrument, due care and maintenance of this product will provide years of dependable service. Please read this manual before using your RC Helicopter .There are three channels: 3.5. All are designed for different ages Children. It includes important safety and operating instructions.
Charging
Charging method: insert the USB charging line into the USB port of the computer, and the charging indicator light will be on; connect the USB charging plug to the charging port of the lithium battery, and the light on the charging line will be off, and the charging time will be about 30 minutes, and the charging will be completed when the charging indicator light on the USB is on
Operating Instructions
- Turn on the switch, LED lighting.
- Open the R/C stich push the throttle from min to max .When frequency is ok, the helicopter will fly.
- To switch between the high and low speed by Press the speed key of the remote control.
- L,R fine turning key, when flying ,press “L” turn left and “R ” turn right.
Gyroscope calibration
If the aircraft is in a disordered flight state or flies to one side, stop flying, and place the aircraft on a flat ground. At the same time, push the left operating rocker downward and the right operating rocker 45 ° to the lower left to correct the gyroscope.
One touch takeoff / landing
Press one key to take off / land and the plane will land slowly.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>