SHANTOU 2355 1 Special Effects Vehicle User Manual

SHANTOU 2355 1 Special Effects Vehicle

Specifications

• Compliance: Part 15 of FCC Rules
• RF Exposure: General RF exposure requirement met
• Usage: Portable exposure condition without restriction

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Guidelines for Proper Operation:

• Reorient or relocate the receiving antenna if needed.
• Increase the separation between the equipment and receiver for] optimal performance.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Special effects vehicle user manual

Thank you for using our company’s toy products. In order to give you a better understanding of this product.Please read the following instructions carefully before use, as they will provide you with a unique operating experience.

Pay attention to
This product is suitable for children aged 3 and above. After assembly/charging by adults, children can play with it.Please use this product under adult supervision. Warning: Please do not disassemble or modify this product without authorization. Any modifications may cause the product lo malfunction.

Special warning:
Causing the battery to be charged using a charging plug with an output voltage of 5V. Do not use a fast charging plug or fast charging cable to avoid dangerous situations such as excessive current output and overheating during charging, which may cause product damage.

production configuration

Watch remote control (remote control has 2 optional) to buy additional.

Body Charge/switch position

Body charging position
Note : The Red Light is on when charging, and the light is off when charging.

Water spray operation instructions
Note: The water plug can not be picked up the whole car swing easily broken.

Remote control frequency matching

1. First turn on the body power switch, body lights flashing, then turn on the remote control power switch, began to frequency, frequency success, body lights long bright.
2. On the frequency is not successful, the remote control power lights and body lights have been flashing, connection is not successful, please repeat the above operation.
3. No operation after the frequency, 1 minute after the remote control car and remote control into hibernation mode, need to re-connect to the frequency.
4. Handle remote control and watch remote control can not be operated at the same time, such as to change another handle remote control or watch remote control must be turned off the remote control and car power, re-frequency.

Remote control function introduction and battery installation mode

Note: Wrong Frequency, right frequency, no operation, sleep after 1 minute, if need to restart the remote control and car switch.

Battery installation: Open the remote control battery cover, 2X1.5 V”AA” non- rechargeable batteries installed in the correct polar direction, and cover the battery cover.

Gravity induction watch remote control function introduction

Note: Wrong Freed yo restore rcy contrarian lar suiter 1 minute,

Operation Instruction of gravity induction watch

The car body battery use note

1. The very pack tes recommenced get ble baitery be fully charged and used again.
2. The charging plug uses an output voltage of 5V
3. Rechargeable batteries can only be charged under adult supervision.
4. Chalmers must be checked regularly a damage to wires, plugs, enclosures and other components.
5. If found damaged should stop using until, until repair is complete, can continue to use.

General troubleshooting Battery matters needing attention of remote control

1.  The battery should be removed and put into the battery room of the remote control, according to the logo.
2. Only use the same or the same battery as recommended.
3. Do not mix old and new batteries or different types of batteries.
4. Remove the drained battery from the remote control to prevent battery leakage and damage to the remote control.

General troubleshooting

Instructions Battery

Chargers that use the toy must be checked regularly to prevent damage to wires and other components. If it is damaged, it must be repaired before it can be used.

Maintenance

1. Can not be close to the source of fire, avoid direct sunlight, high temperature and humidity or long-term placed in the car, can avoid circuit short-circuit, fire.
2. Remove the battery from the remote control when not playing. And the remote control car, remote control back into the box packaging, can avoid in transport or storage damage or deformation.
3.  Remote control car should be gently wiped with a damp cloth.

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>