SHANTOU CITY OURUI INDUSTRIAL Co LTD 3737-1AD Remote Control Toy Instruction Manual
- June 1, 2024
- SHANTOU CITY OURUI INDUSTRIAL Co LTD
Table of Contents
SHANTOU CITY OURUI INDUSTRIAL Co LTD 3737-1AD Remote Control Toy
Remote control toy
- Open the battery compartment: Align the screwdriver with the small contact point on the battery cover and gently press down while dragging the battery cover to open.
- Insert one 3.7V rech argeable battery batteries into the toy battery compartmen of with correct polarity.
- Insetr 2 x 1.5V “AA” batteries into the battery compartment of the remote controller with correct polarity.
- Close the battery compartment: Tighten the screw by tuming clockwise with a Phillips screwdriver.
Product Specifications
- Toy Type: Remote control toy
- Battery Requirement: One 3.7V rechargeable battery (included)
- Additional Batteries: 2 x 1.5V AA batteries for the remote controller
- Waterproof Function: Yes
- Remote Control Distance: 30-40 meters in an unobstructed environment
- Recommended Environment: Calm clear water, pools, and shallow areas
caution:
- This product is a children’s toy that will swim in the water through the 2.4GHz wireless remote control.
- This product has the function of automatic pairing, After successful pairing, It can only bge controlled one-to-one.
- While pairing, Put hte toys and remote controller as close as possible.
- The toy has the function of sensing water, The motor will stop running once is taken out of the water.
- The toy possesses a waterproof function.
- The remote controller possesses a waterproof function.
- Distance of remote control: 30-40 meters in an unobstructed environment.
- Operate only in calm clear water, Pools and shallow are recommended
- After each use, Wipe with a towel and allow to dry completely.
- Do not operate near concrete wails which may disturb transmission.
- You’re designed for operation in fresh water, Do not submerge the water for a long time.
- Maximum 10 players at a time.
- Do not press the gasboat into the water for a long time.
- Please install the gasboat battery according to the correct direction.
WARNING: .
Never allow young children to play in or around water without adult
supervision. The toy can only be used in water after it is installed in
accordance with the instructions.
Product Usage Instructions:
operate:
How To PIay:
-
Put the toy into the water, the gasboat headlight flashes, then turn on the remote control, the remote control indicator keeps on and the gasboat headlight stops flashing, then pairing is completed.
(Note: If the red light of the front indicator keeps flashing, it means that pairing is failed; pick up the toy from the water, turn off the remote control, operate again according to the above method until successful pairing). -
Left key of the remote control: Automatically demonstrates the swimming process of the toy
-
Right key of the remote control: Start/stop jetting water of the gasboat (water jetting duration is 20 seconds)
Battery Installation:
- Open the battery compartment by aligning the screwdriver with the small contact point on the battery cover and gently pressing down while dragging the cover to open.
- Insert one 3.7V rechargeable battery into the toy’s battery compartment with the correct polarity.
- Insert 2 x 1.5V AA batteries into the remote controller’s battery compartment with the correct polarity.
- Close the battery compartment by tightening the screw clockwise with a Phillips screwdriver.
Battery Notice:
- The remote control requires two 1.5VAA non-rechargeable batteries (not provided);
- The toy body requires one set of 3.7V rechargeable batteries (provided);
- Do not charge the non-rechargeable batteries;
- Do not mix new and old or different types of batteries;
- Please note the polarity when installing or replacing the battery;
- Please timely take outthe battery with low power;
- Do not short circuit the power supply terminal;
- Take out and install the rechargeable battery: Loosen the main battery compartment screws with screwdriver, open the battery cover, connect and pull out the battery connector socket in the correct direction, then close the battery cover, tighten the screws of the battery cover with screwdriver.Thetoy can only be used in water after it is installed in accordance with the instructions;
- This rechargeable battery is non-replaceable, and the rechargeable battery can only be charged under the supervision of adult;
- Connect the supplied USB charger to the power supply with outputvoltage of 5.0V 2A; (such as: USB mobile phone charger, computer USB interface) to charge the battery;
- During charging, the USB charger will be slightly warm,which is normal;
- The product can only be charged with the recommended USB charger, and the USB chargeris not a toy;
- Regularly check whether the wire, plug, casing and other parts of the USB charger and the recommended charger are damaged. If there’s any damage, stop using it before itis repaired;
- Disconnect the USB charger before cleaning the toy;
- Please do not disassemble or throw the bad batteries and battery pack into fire or water to avoid accident;
- The toy must not be used by children underage 3.
- Please keep your hands dry when charging, and keep the battery slot dry after taking out the battery.
Product Functionality:
- The toy can swim in water via 2.4GHz wireless remote control.
- Automatic pairing function; only controllable one-to-one after successful pairing.
- Toy senses water; motor stops running when out of water.
- Waterproof function for both toy and remote controller.
Product Safety:
- Wipe the toy with a towel after each use and allow it to dry completely.
- Do not allow young children to play in or around water unsupervised.
- Only operate in fresh water; do not submerge for a long time.
- Maximum of 10 players can use the toy simultaneously.
Operating Instructions:
- Functions: Forward, Backward, Swim to the right, Swim to the left, Swim left and back, Swim right and back.
- Remote Control Features: Start/stop jetting water, Water jetting duration is 20 seconds. =
Warning
To assure continued compliance, any changes or modifications not expressly
approved by the party.Responsible for compliance could void the user’s
authority to operate this equipment.
FCC Statement
This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in the portable exposure condition without restriction.
FAQ:
Q: What should I do if the toy stops working in water?
A: Ensure the toy is fully submerged and that the batteries are correctly
installed. If issues persist, contact customer support.
Q: Can the toy be used in saltwater environments?
A: It is recommended to operate the toy in fresh water only to prevent damage.
Q: How do I know when the toy’s batteries need recharging?
A: If the toy starts to operate slower than usual or stops abruptly, it may be
time to recharge the batteries.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>